Abstract:Waterjet-assisted laser drilling technology facilitates the fabrication of high-quality micro-holes by utilizing the collaborative benefits of waterjets and lasers. In this study, the coaxial waterjet-assisted laser drilling (CWALD) technique was employed to improve the properties of micro-holes during femtosecond laser drilling. Based on computational fluid dynamics (CFD) simulations, the stability of the waterjet was initially verified by optimizing the structure of the watercourse and nozzle shape in the CWALD device. Furthermore, a comparative experiment between laser direct drilling (LDD) and CWALD revealed that while CWALD can produce well-rounded micro-holes with a high aspect ratio, it exhibits lower efficiency and results in a larger heat-affected zone (HAZ). To address these drawbacks associated with CWALD, a two-step coaxial waterjet-assisted composite laser drilling (TS-CWALD) method was proposed. TS-CWALD involves applying CWALD for secondary modification of micro-hole shape following LDD with punching. This modification process is pivotal for enhancing drilling accuracy but requires consideration of multiple parameters. For this purpose, regression models were established for the inlet diameter, outlet diameter, and taper; response surface methodology was then employed to optimize these parameters. Subsequently, interactive effects analysis was conducted on different responses based on laser pulse energy, frequency, modification speed, and number of modification cycles. The adequacy of the developed models was subsequently verified using analysis of variance methods. Finally, the successful fabrication of a film hole with an inlet diameter of 205 μm and an outlet diameter of 200 μm, featuring a taper of only 0.2°, was achieved ultimately through meticulous parameter optimization. Furthermore, the micro-hole retained a minimal HAZ. The optimized parameters encompassed a pulse energy of 20.6 μJ, frequency of 127 kHz, modification speed of 3 mm/s, and shape modification carried out over 335 cycles.

Effect of multi-parameter optimization of water-laser coupling device and nozzle geometry on the stability of water-guided laser beam

Numerical simulation of the stability of water fiber-optic in water jet-guided laser machining

Experimental investigation and optimization of modification during coaxial waterjet-assisted femtosecond laser drilling

Water jet guided high-power laser energy transmission loss analysis

Simulation and experimental verification of water-guided laser processing by a water-gas shrinkage laminar flow method

Simulation and Optimization of the Nozzle Section Geometry for a Suspension Abrasive Water Jet

Multi-focus water-jet guided laser: For improving efficiency in cutting superalloys

Design and experiment for a numerical control nanosecond water-jet-guided laser processing test bench

Multi-objective Numerical Simulation of Geometrical Characteristics of Laser Cladding of Cobalt-Based Alloy Based on Response Surface Methodology

Laser and water-jet fiber coupling technology for water-jet guided laser micromachining

Laser coupling in waterjets subject to jet instabilities, laser parameters, and alignment errors

Numerical investigation of various laser–waterjet coupling methods on spot power density distribution

Experimental Investigation and Optimization of Laser Induced Plasma Micromachining Using Flowing Water

High coupling efficiency with large axial direction coupling adjustment range in water-jet guided laser

On the maintenance of processing stability and consistency in laser-directed energy deposition via machine learning

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Numerical investigations of water jet-guided laser cutting of silicon

Numerical simulation of effect of laser power and assistant gas on laser cutting ability

Study on water jet stability and processing morphology of groove cutting using water jet guided laser

Optimization of multistage femtosecond laser drilling process using machine learning coupled with molecular dynamics

Structure optimization of submerged water jet cavitating nozzle with a hybrid algorithm