Abstract:Current design procedures for complicated three-dimensional structural components with component interactions may not necessarily result in optimum designs. The wrist pin end design of the connecting rod with an interference fit is governed by the stress singularity in the region where the wrist pin breaks contact with the connecting rod. Similar problems occur in a wide variety of structural components which involve interference fits. For a better understanding of the problems associated with obtaining optimum designs for this important class of structural interaction only the design problems associated with the wrist pin end of the rod are addressed in this study. This paper demonstrates a procedure for designing a functional and minimum weight wrist pin end of an automobile engine connecting rod with an interference fit wrist pin. Current procedures for Finite Element Method (FEM) model generation in complicated three-dimensional components are very time consuming especially in the presence of stress singularities. Furthermore the iterative nature of the design process makes the process of developing an optimum design very expensive. This design procedure uses a generic modeler to generate the FEM model based on the values of the design variables. It uses the NASTRAN finite element program for structural analysis. A stress concentration factor approach is used to obtain realistic stresses in the region of the stress singularity. For optimization, the approximate optimization strategy in the COPES/CONMIN program is used to generate an approximate design surface, determine the design sensitivities for constrained function minimization and obtain the optimum design. This proposed design strategy is fully automated and requires only an initial design to generate the optimum design. It does not require analysis code modifications to compute the design sensitivities and requires very few costly NASTRAN analyses. The connecting rod design problem was solved as an eight design variable problem with five constraints. A weight reduction of nearly 27 percent was achieved over an existing design and required only thirteen NASTRAN analyses. It is felt that this design strategy can be effectively used in an engineering environment to generate optimum designs of complicated three-dimensional components.

Optimal Design of Automobile Connecting Rod Basic on Finite Element

Finite Element Analysis of a connecting rod in ANSYS: An overview

Optimizing the Design and Material used for Connecting Rod through Finite Element Simulation

Optimization design of titanium alloy connecting rod based on structural topology optimization

Optimization of the Wrist Pin End of an Automobile Engine Connecting Rod With an Interference Fit

Numerical Simulation of Pre-forging for Connecting Rod of Automobile Engine and Optimization of Its Pre-forging Billet

Structural Optimization Design and Strength Test Research of Connecting Rod Assembly of High-Power Low-Speed Diesel Engine

DESIGN, ANALYSIS AND COMPARISON OF VARIOUS MATERIALS FOR CONNECTING ROD

Static Structural Analysis of Different Materials for Connecting Rod

The Design Optimization for Hot Forging Process of Connecting-rod Based on Approximate Model and Numerical Simulation

Numerical optimization on hot forging process of connecting rods based on RSA with experimental verification

Lubricating Simulation Analysis of Connecting Rod Bearing Based on AVL-EXCITE

On Finite Element Analysis and Optimum Design of Crankshaft

Microstructure and Mechanical Properties of Fe-C-Cu Powder-Forged Connecting Rod

Optimization Analysis of Automobile Tie Rod using FEA and Experimental Approach

Development of Engine Connecting Rod Tension and Compression Fatigue Simulation Test Rig

Analysis of Piston Optimization Design Based on Finite Element Analysis

Study on the Optimal Design of Engine Cylinder Head by Parametric Structure Characterization with Weight Distribution Criterion

Comparison of grey wolf, whale, water cycle, ant lion and sine-cosine algorithms for the optimization of a vehicle engine connecting rod

2D Finite Element Analyses on the Connecting Rod Tooth-Shape Contact Surface Fretting Behavior