Abstract:In the machining of complicated surfaces, the cutters with large length/diameter ratios are used widely and the deformation of the machining system is one of the principal error sources. During the process planning stage, the cutting direction angle, the cutter lead and tilt angles are usually optimized to minimize the force induced error. It may lead to a low machining efficiency for bullnose end mills, as the material removal rates are different largely for different machining angles. In this paper, the influence mechanism of the machining angles on the force induced error is studied based on the models of the instantaneous cutting force when the cutter flute traveling through the cutting contact point and the stiffness of the machining system. In order to evaluate the machining angles, the force induced error/efficiency indicator (FEI) is defined as the division of the force induced error and the equal volume sphere of the removed material. FEI is dimensionless, with the lower FEI, the lower force induced error and the higher machining efficiency. For optimal selection of the machining angles, the critical FEI is calculated with the constraint of force induced error and the desired material removal rate, and the critical FEI separate the set of the machining angles into two subsets. After the feed rate scheduling process, the machining angles in the optimal subset would have higher machining accuracy and efficiency, while the machining angles in the other subset have lower machining accuracy and efficiency. Through the machining experiment of five axis machining and freeform surface machining, the effectiveness and superiority of the proposed FEI method is verified with a bullnose end mill, which can improve the machining efficiency with the constraint of force induced error.

Accurate Modeling of Working Normal Rake Angles and Working Inclination Angles of Active Cutting Edges and Application in Cutting Force Prediction

Mechanisms and predictive force models for machining with rake face textured cutting tools under orthogonal cutting conditions

Three-dimensional turning force prediction based on hybrid finite element and predictive machining theory considering edge radius and nose radius

Study on Analytical Model of Surface Roughness Prediction in NC Machining

Analytical prediction of cutting forces in cylindrical turning of 304 stainless steel using unequal division shear zone theory

Forces in Hard Turning of 51crv4 with Wiper Cutting Tool

A hybrid model for turning force based on shear and extrusion deformation considering cutting-edge radius

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Finite element simulation of cutting process under the worn tool edge geometries

Research on Force-Saving Mechanism of Cutting Tool with Variable Curvature Directrix Rake Face Configuration

The prediction of surface roughness and tool vibration by using metaheuristic-based ANFIS during dry turning of Al alloy (AA6013)

Surface roughness prediction for turning based on the corrected subsection theoretical model

Influence mechanism of machining angles on force induced error and their selection in five axis bullnose end milling

A Cutting Force Model for a Waved-Edge End Milling Cutter

An accurate mathematical model for ball end mills with chisel edge

Analysis of Critical Negative Rake Angle and Friction Characteristics in Orthogonal Cutting of AL1060 and T2.

A prediction method of cutting force coefficients with helix angle of flat-end cutter and its application in a virtual three-axis milling simulation system

Modeling and Simulation for the Critical Bending Force of Power Chucks to Guarantee High Machining Precision

A new cutting force prediction method in ball-end milling based on material properties for difficult-to-machine materials

Generic Cutting Force Modeling Comprehensively Considering Tool Edge Radius, Tool Flank Wear and Tool Runout in Micro-End Milling

Prediction of Cutting Forces in Flank Milling of Parts with Non-Developable Ruled Surfaces