Abstract:Results are presented for modelling of the evaporation and magnetron sputter deposition of Zn(x)O(y) onto an O-terminated ZnO (0001¯) wurtzite surface. Growth was simulated through a combination of molecular dynamics (MD) and an on-the-fly kinetic Monte Carlo (otf-KMC) method, which finds diffusion pathways and barriers without prior knowledge of transitions. We examine the effects of varying experimental parameters, such as substrate bias, distribution of the deposition species and annealing temperature. It was found when comparing evaporation and sputtering growth that the latter process results in a denser and more crystalline structure, due to the higher deposition energy of the arriving species. The evaporation growth also exhibits more stacking faults than the sputtered growth. Post-annealing at 770 K did not allow complete recrystallization, resulting in films which still had stacking faults where monolayers formed in the zinc blende phase, whereas annealing at 920 K enabled the complete recrystallization of some films to the wurtzite structure. At the latter temperature atoms could also sometimes be locked in the zinc blende phase after annealing. When full recrystallization did not take place, both wurtzite and zinc blende phases were seen in the same layer, resulting in a phase boundary. Investigation of the various distributions of deposition species showed that, during evaporation, the best quality film resulted from a stoichiometric distribution where only ZnO clusters were deposited. During sputtering, however, the best quality film resulted from a slightly O rich distribution. Two stoichiometric distributions, one involving mainly ZnO clusters and the other involving mainly single species, showed that the distribution of deposition species makes a huge impact on the grown film. The deposition of predominantly single species causes many more O atoms at the surface to be sputtered or reflected, resulting in an O deficiency of up to 18% in the deposited film and therefore resulting in more stacking faults and phase boundaries. The methods used allow analysis of key mechanisms that occur during the growth process and give hints as to the optimum conditions under which complete crystalline layers can form.

Optical and structural characterization of zinc oxide thin films upon ion beam assisted smoothing

The growth of nanoscale ZnO films by pulsed-spray evaporation chemical vapor deposition and their structural, electric and optical properties

Effect of Solution Concentrations on Crystal Structure, Surface Topographies and Photoluminescence Properties of ZnO Thin Films

Effect of solution concentration on surface morphology, optical properties and solar light response of ZnO thin films

Structural and Optical Characterizations of ZnO Films Grown by Reactive Electron Beam Evaporation

Surface modification by high-energy heavy-ion irradiation in various crystalline ZnO facets

Smoothing of Zno Films by Gas Cluster Ion Beam

Methodical engineering of defects in Mn$_x$Zn$_{1-x}$ O($x$ = 0.03, and 0.05) nanostructures by electron beam for nonlinear optical applications: A new insight

Enhancement And Patterning Of Ultraviolet Emission In Zno With An Electron Beam

Structural and Optical Properties of Highly (110)-Oriented Non-Polar ZnO Evaporated Films on Si Substrates

Tuning the structural, morphological, and optical properties of zinc (8-hydroxyquinoline) thin films by laser-irradiation for optoelectronic applications

Nanosecond-laser annealing of zinc oxide thin-films: The effect of the laser wavelength and fluence

Impact of ion beam irradiation on optical and structural properties of nanocomposite ZnO thin films

Ion-Implantation Induced Nano Distortion Layer and Its Influence on Nonlinear Optical Properties of Zno Single Crystals

Modelling the growth of ZnO thin films by PVD methods and the effects of post-annealing

X-ray photoelectron spectroscopy, Raman and photoluminescence studies on formation of defects in Cu:ZnO thin films and its role in non-linear optical features

Structural and Optical Properties of Nonpolar $(11 \bar{2}0)$ ZnO Films Grown by Plasma-Assisted Molecular-Beam Epitaxy

Optical property modification of ZnO: Effect of 1.2 MeV Ar irradiation

Influence of Swift Heavy Ion Beam Irradiation on Optical, Structural, and Surface Morphological Properties of WO3 Thin Films Grown by RF Sputtering Method

Control over the Surface Properties of Zinc Oxide Powders via Combining Mechanical, Electron Beam, and Thermal Processing

Modification of surface morphology and lattice order in nanocrystalline ZnO thin films prepared by spin-coating sol–gel method