Insights into tuning toluene oxidation intermediates by phase structures of Mn-based catalysts

Jianshen Wang,Di Zhang,Gangguo Zhao,Hua Yuan,Dan Liu,Alex T. Kuvarega,Bhekie B. Mamba,Hu Li,JianZhou Gui,Jianzhou Gui
DOI: https://doi.org/10.1016/j.colsurfa.2024.133357
IF: 5.518
2024-02-15
Colloids and Surfaces A Physicochemical and Engineering Aspects
Abstract:MnOx catalysts with different active sites were prepared through a Mn-MOF-derived method, and their active structures gradually changed from Mn 3 O 4 -Mn 2 O 3 , Mn 2+ -coupled-Mn 2 O 3 , and finally to Mn 2 O 3 by increasing calcination temperature. The optimum MnOx-500 catalyst calcined at 500oC, in the form of Mn 2+ coupled Mn 2 O 3 dual catalytic sites, exhibited the best catalytic performance and stability for toluene oxidation due to the enhanced low-temperature redox properties, weakest Mn-O bond and the highest percentage of Mn 2+ species. The possible route of toluene oxidation was proposed based on in-situ FTIR, and interestingly, all the reaction intermediates, including benzyl alcohol, benzaldehyde, benzoate, phenol, and maleate, were produced on MnOx-400, while for MnOx-500, Mn 2+ -coupled-Mn 2 O 3 , only benzaldehyde, benzoate, and maleate were formed, and the rate-determining step for conversion of benzoate into ring-oping products requires less energy. The work opens a new avenue for the precise construction of active sites based on multivalent metal oxide catalysts for the degradation of volatile organic compounds.
chemistry, physical
What problem does this paper attempt to address?