Supercritical Operation of Bearingless Cross-Flow Fan

Ivana Bagaric,Daniel Steinert,Thomas Nussbaumer,Johann W. Kolar,Johann Walter Kolar
DOI: https://doi.org/10.3390/machines12040223
IF: 2.899
2024-03-28
Machines
Abstract:This paper presents a decoupled bearingless cross-flow fan (CFF) that operates at a supercritical speed, thereby increasing the maximum achievable rotational speed and fluid dynamic power. In magnetically levitated CFF rotors, the rotational speed and fan performance are limited by the bending resonance frequency. This is primarily defined by the low mechanical bending stiffness of the CFF blades, which are optimised for fluid dynamic performance, and the heavy rotor magnets on both rotor sides, which add significant mass but a minimal contribution to the overall rotor stiffness. This results in detrimental deformations of the CFF blades in the vicinity of the rotor bending resonance frequency; hence, the CFF is speed-limited to subcritical rotational speeds. The novel CFF rotor presented in this study features additional mechanical decoupling elements with low bending stiffness between the fan blades and the rotor magnets. Thus, the unbalance forces primarily deform the soft decoupling elements, which enables them to pass resonances without CFF blade damage and allows rotor operation in the supercritical speed region due to the self-centring effect of the rotor. The effects of the novel rotor design on the rotor dynamic behaviour are investigated by means of a mass-spring-damper model. The influence of different decoupling elements on the magnetic bearing is experimentally tested and evaluated, from which an optimised decoupled CFF rotor is derived. The final prototype enables a stable operation at 7000 rpm in the supercritical speed region. This corresponds to a rotational speed increase of 40%, resulting in a 28% higher, validated fluid flow and a 100% higher static pressure compared to the previously presented bearingless CFF without decoupling elements.
engineering, mechanical, electrical & electronic
What problem does this paper attempt to address?
### Problems Addressed by the Paper This paper aims to address the speed limitation issue of the bearingless cross-flow fan (CFF) at the critical bending resonance frequency, thereby improving its hydrodynamic performance. #### Main Issues - **Speed Limitation of Bearingless Cross-Flow Fan**: The rotational speed and performance of the bearingless CFF are limited by the bending resonance frequency, primarily due to the low mechanical bending stiffness of the CFF blades and the additional mass of the heavy magnets at both ends. - **Deformation of CFF Blades**: When approaching the critical bending resonance frequency, the CFF blades undergo plastic deformation, preventing them from surpassing this frequency and thus can only operate at subcritical speeds. #### Solutions - **Introduction of Decoupling Elements**: By introducing low-stiffness decoupling elements between the CFF blades and the rotor magnets, the unbalanced forces mainly act on these decoupling elements. This allows the rotor to pass through the resonance frequency without damaging the CFF blades and enables operation in the supercritical speed region. - **Optimized Design**: Analyzing the impact of decoupling elements on the rotor's dynamic behavior using a mass-spring-damping model, and experimentally testing the effects of different decoupling elements on the magnetic bearings, ultimately resulting in an optimized decoupled CFF rotor design. #### Experimental Validation - **Increased Maximum Speed**: The final prototype can stably operate in the supercritical speed region at 7000 rpm, which is a 40% increase in speed compared to the previous bearingless CFF without decoupling elements. Additionally, the fluid flow increased by 28%, and the static pressure increased by 100%.