Abstract:We report the use of high magnetomechanical coupling ferrites in magnetoelectric (ME) layered composites. Bilayer samples combining $(Ni_{0.973} Co_{0.027})_{1-x} Zn_x Fe_2 O_4$ ferrites ($x = 0-0.5$) synthesized by non conventional reactive Spark Plasma Sintering and commercial lead zirconate titanate (PZT) were characterized in term of ME voltage coefficients measured at sub-resonant frequency. Strong ME effects are obtained and we show that an annealing at 1000$^\circ$C and a quenching in air improve the piezomagnetic behavior of Zn-rich compositions. A theoretical model that predicts the ME behavior was developed, focusing our work on the demagnetizing effects in the transversal mode as well as the longitudinal mode. The model shows that: (i) high ME coefficients are obtained when ferrites with high magnetomechanical coupling are used in bilayer ME composites, (ii) the ME behavior in transversal and longitudinal modes is quite similar, and differences in the shapes of the ME curves are mainly due the demagnetizing effects, (iii) in the transversal mode, the magnetic field penetration depends on the ferrite layer thickness and the ME coefficient is affected accordingly. The two later points are confirmed by measurements on ME samples and calculations. Performances of the ME composites made with high magnetomechanical coupling ferrites are compared to those obtained using Terfenol-D materials in the same conditions of size, shape, and volume ratio. It appears that a ferrite with an optimized composition has performances comparable to those obtained with Terfenol-D material. Nevertheless, the fabrication processes of ferrites are quite simpler. Finally, a ferrite/PZT based ME composite was used as a current sensor.

Power deposition in the He bath induced by the Z gradient coil in the 11.7T Iseult magnet: theory versus measurements

Finite Element Analysis of Gradient Z-Coil Induced Eddy Currents in a Permanent MRI Magnet

Simulation of Thermo-Mechanical Stresses After a Quench in the 15 T Test Facility Dipole Magnet

Behavior during quenches of a 40 T magnet made of LTS and HTS parts

Commissioning, Performance, and Effect of the Quench Current-boosting Device on a Dedicated Superconducting Magnet

The possible influence of third-order shim coils on gradient–magnet interactions: an inter-field and inter-site study

Modeling of Quench in the ITER Poloidal Field Coils

Numerical study of RF power coupling in fusion-relevant single- and multi-driver H$^-$ ion sources

Exploration of Parameters That Affect High Field Q-Slope

Quench position reconstruction through harmonic field analysis in superconducting magnets

Z-Gradient Coil Design with Improved Anti-eddy Performance for MRI System with Opposed Permanent Magnets

Performance of a MQXF Nb3Sn Quadrupole Magnet Under Different Stress Level

Power deposition studies for standard and crystal-assisted heavy ion collimation inthe CERN Large Hadron Collider

Magnetization in superconducting corrector magnets and impact on luminosity-calibration scans in the Large Hadron Collider

Magnetoelectric effect in layered ferrite/PZT composites. Study of the demagnetizing effect on the magnetoelectric behavior

Magnetic field gradient in K-Rb- 21 Ne comagnetometer: Measurement, decoupling and suppression

Variable high gradient permanent magnet quadrupole (QUAPEVA)

Optimized Field/Circuit Coupling for the Simulation of Quenches in Superconducting Magnets

Reduced Order Modelling for the Simulation of Quenches in Superconducting Magnets

Non-monotonic field-dependence of the ZFC magnetization peak in some systems of magnetic nanoparticles

Delamination behaviors of an epoxy-impregnated REBCO pancake coil during a quench