Abstract:Rail grinders belonging to special vehicles have fewer accidents than general railroad vehicles and parts, and the causes are diverse. Therefore, there is a lack of basic data for inspection methods and preventative measures necessary for accident prevention, and the collection and analysis of accident cases are also necessary. In this paper, a failure analysis of the recently derailed rail grinding car's rotating shaft was conducted. Various analyses, including fractography, chemical analysis, metallography and hardness measurement, were performed on the failed shaft. In the fracture surface of the shaft, ratchet marks and fatigue striations indicative of fatigue failure were observed. Consequently, it was confirmed that the failure of the shaft was attributed to fatigue, with the primary cause being identified as the cracks found on the fillet area surface. Chemical analysis of the observed inclusions in the sample revealed manganese (Mn) at 6.16 wt% and sulfur (S) at 1.35 wt%. These are attributed to non-metallic MnS inclusions, which are presumed to have adversely affected the fatigue strength of the material. Additionally, hardness deficiency due to heat treatment defects on the shaft surface was identified. The surface hardness measured approximately HV400, suggesting that it is desirable to achieve a surface hardness of HV600 or HRC55 or higher during high-frequency heat treatment. Lastly, the finish state of the fillet area surface was not smooth. Given that the fillet area is a region where stress concentration occurs, the presence of such machining traces raises the possibility of progressing into fatigue cracks. Finite element analysis revealed that the von-Mises stress was less than the yield strength of the material, and a safety factor based on the yield strength was calculated to be 3.5. The results confirmed that fatigue cracks in the fillet area were caused by the hardness deficiency due to the poor heat treatment, the rough surface finish, and the presence of non-metallic inclusions.

Failure analysis of right-front wheel hub rim of nose gear of a cargo aircraft

Failure analysis of one main wheel hub bolt fracture of A320 aircraft

Fracture Failure Analysis of Flywheel Hub Served in Heavy-Fuel Aviation Piston Engine

ANALYSIS STUDY ON BENDING FATIGUE TEST OF AUTOMOBILE WHEELS

Fracture failure analysis on Alloy783 bolts in medium-pressure valve bonnets of USC units

Failure analysis on abnormal cracking of the main landing gear door of a civil aircraft

Fracture failure analysis of vertical arm of rear axle

Failure Analysis of Crankshaft in a Heavy-duty Vehicle Engine

Microstructure Modifications due to Abusive Grinding Resulted in Unexpected Catastrophic Failure of Main Landing Gear in Civilian Aircraft

Casting Defects Induced Fatigue Damage in Aircraft Frames of ZL205A Aluminum Alloy – A Failure Analysis

Failure analysis of the rotating shaft in the rail grinding car

Electron Microanalysis of Fracture Surface of Tailing Spout Regulation of Aircraft Engine

Gear Rim Failure Prediction Based on Fracture Mechanics

Failure Analysis on the Rivet

Failure Analysis of Architectural Windlass' Braked Wheel

Failure Analysis of an Aluminum Alloy Material Framework Component Induced by Casting Defects

A study on the of rolling contact fatigue mechanism of ZC-L cast wheel steel

Failure analysis of an aero-engine inter-shaft bearing due to clearance between the outer ring and its housing

Modeling of Fatigue Mechanism and Reliability Analysis of Nose Landing Gear under Impact Loading

Study on damage tolerance and remain fatigue life of shattered rim of railway wheels

Prediction of fracture in hub-hole expanding process using a new ductile fracture criterion