Abstract:The interaction mechanism between the tool flank wear and the cutting force, in milling Ti-6Al-4V, is of significance for its further development. However, the relationship between the tool flank wear and the cutting force should be further investigated under ultrasonic-assisted milling. In this study, the longitudinal-torsional ultrasonic-assisted milling (LTUAM) Ti-6Al-4V in dry cutting was evaluated by comparing with conventional milling (CM). With the consideration of the ultrasonic vibration on the chip flow angle, a novel cutting force model in terms of the tool flank wear was developed by discretizing the side edge to apply the oblique model. Wherein the stress evolution both on the shear plane and the flank plane was analyzed, as well as the swinging range of chip flow angle resulted from ultrasonic vibration. In addition, the coefficients of the cutting force were calibrated through the mechanical method. The model could predict the cutting force evolution with different flank wear bandwidth (VB), and optimize the machining parameters. The experimental results indicated the errors between the model and the test were 19.1 % and 12.9 % in the feed (x) and the normal (y) direction of the tool coordinate system (o-xyz), respectively. Through time-frequency transformation, the behavior of the cutting force both in CM and LTUAM was further explained. Besides, the growing amplitude was beneficial to restrain the flank wear apart from the overgrowing amplitude, while the growing helix angles resulted in the serious tool flank wear in LTUAM. For the machined surface texture, the cutter scratches parallel to the feed direction dominated the machined surface in CM while the LTUAM surface featured by the order wave textures.

Effect of contact stiffness on cutter flank friction and wear in milling process considering cutting vibration

Effects of Tool Flank Wear on Orthogonal Cutting Process of Aluminum Alloy

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Cutting Force Model of Longitudinal-Torsional Ultrasonic-Assisted Milling Ti-6Al-4V Based on Tool Flank Wear

Investigation on the Tool Wear Suppression Mechanism in Non-Resonant Vibration-Assisted Micro Milling

Study the effect of anti-vibration edge length on process stability of milling thin-walled Ti-6Al-4V alloy

Tool wear rate prediction in ultrasonic vibration-assisted milling

Influences of shim stiffness on the vibration response of tool-shim system and the impact fracture resistance of cutting tool in intermittent cutting

Cross-scale identification method for friction damage on the tool flank of high-feed milling cutter

Investigation of the tool flank wear influence on cutter-workpiece engagement and cutting force in micro milling processes

A novel activated sticking-sliding friction model along tool-chip interface and mechanism analysis in high-speed machining of Ti6Al4V

The recognition method for the fractal and the dynamic on the tool flank of a high-energy-efficiency milling cutter

Investigation on cutting forces and tool wear in high-speed milling of Ti-6Al-4V assisted by longitudinal torsional ultrasonic vibrations

A Simulation Study on the Effect of Micro-Textured Tools During Orthogonal Cutting of Titanium Alloy Ti-6Al-4V

Analytical modeling of milling residual stress under different tool wear conditions

Role of Tool Flank Wear and Machining Speed in Developing of Residual Stress in Machined Surface During High Speed Machining of Titanium Alloys

Analyzing The Effect Of Tool Edge Radius On Cutting Temperature In Micro-Milling Process

Study on Residual Stresses in Ultrasonic Torsional Vibration Assisted Micro-Milling

An improved time-varying stability analysis of micro milling considering tool wear

Study on design of conical arc side-edge milling cutter and cutting performance under ultrasonic-assisted condition

Effect of tool wear in ultrasonic vibration-assisted micro-milling