Abstract:The growing interest in the use of building materials with a reduced carbon footprint was the aim of this research assessing the impact of four different types of low-emission cements on the properties of cement concretes used for the construction of local roads. This research work attempted to verify the strength characteristics and assess the durability of such solutions, which used the commonly used CEM I 42.5 R pure clinker cement and three multi-component cements: CEM II/A-V 42.5 R, CEM III/A 42.5 N-LH/HSR/NA, and CEM V/A S-V 42.5 N-LH/HSR/NA. Cement was used in a constant amount of 360 kg/m3, sand of 0/2 mm, and granite aggregate fractions of 2/8 and 8/16 mm. This research was carried out in two areas: the first concerned strength tests and the second focused on the area of assessing the durability of concrete in terms of frost resistance F150, resistance to de-icing agents, water penetration under pressure, and an analysis of the air entrainment structure in concrete according to the PN EN 480-11 standard. Analyzing the obtained test results, it can be concluded that the highest compressive strength of more than 70 MPa was obtained for CEM III concrete, 68 MPa for CEM V concrete, and the lowest for CEM I cement after 90 days. After the durability tests, it was found that the smallest decrease in compressive strength after 150 freezing and thawing cycles was obtained for CEM III (−0.9%) and CEM V (−1.4%) concretes. The high durability of concrete is confirmed by water penetration tests under pressure, because for newly designed recipes using CEM II, CEM III, and CEM V, water penetration from 17 mm to 18 mm was achieved, which proves the very high tightness of the concrete. The assessment of the durability of low-emission cements was confirmed by tests of resistance to de-icing agents and the aeration structure performed under a microscope in accordance with the requirements of the PN-EN 480-11 standard. The obtained analysis results indicate the correct structure and minimal spacing of air bubbles in the concrete, which confirms and guarantees the durability of concrete intended for road construction. Concretes designed using CEM V cement are characterized by a carbon footprint reduction of 36%, and for the mixture based on CEM III, we even observed a decrease of 39% compared to traditional concrete. Concrete using CEM II, CEM III, and CEM V cements can be successfully used for the construction of local roads. Therefore, it is necessary to consider changing the requirements of the technical specifications recommended for roads in Poland.

JUSTIFICATION FOR THE BUILDING MATERIALS REQUIREMENTS IN THE ASPHALT PAVEMENT REPAIR BY THE CEMENT CONCRETE LAYERS

Structural Mechanics Analysis of Asphalt Pavement Using Large Stone Asphalt Mixture As Base

DEVELOPMENT OF VARIOUS TYPES OF CEMENTS FOR THE DEVICE OF STRUCTURAL LAYERS OF ROAD PAVEMENT BASED ON ASPHALT GRANULAR CONCRETE MIXTURES

Characteristics of Damaged Asphalt Mixtures in Tension and Compression

Experimental study on strength and abrasion-resistance enhancement admixture

STRENGTH, ABRASION RESISTANCE AND FROST RESISTANCE OF FIBER CONCRETE OF HARD PAVEMENT WITH BASALT FIBER AND AIR-ENTRAINING ADMIXTURE

Development and Optimization of Ultimate Performance Self-Levelling Epoxy Asphalt Concrete (USEA) for Prefabricated Deck Pavement

Research of Strength, Frost Resistance, Abrasion Resistance and Shrinkage of Steel Fiber Concrete for Rigid Highways and Airfields Pavement Repair

Study on the Performance and Application of High Performance Pavement Portland Cement Concrete

Performance Research of Cement Concrete Pavements with a Lower Carbon Footprint

INFLUENCE OF FIBER REINFORCEMENT ON CONCRETE SHRINKAGE FOR RIGID ROAD AND AIRFIELD PAVEMENT REPAIR

TECHNICAL AND ECONOMIC JUSTIFICATION OF THE FEASIBILITY OF USING THE TECHNOLOGY OF LAYING COVERS FROM DRAINING ASPHALT CONCRETE

Influence of fibers and hardening accelerator on the concrete for rigid pavements

COMPARATIVE CHARACTERISTICS OF THE TECHNOLOGIES OF ARRANGEMENT OF RIGID PAVEMENT LAYERS FROM ROLLER-COMPACTED CONCRETE MIXTURES AND TRADITIONAL PAVING CONCRETE MIXTURES

Asphalt-Cement Concretes with Reclaimed Asphalt Pavement and Rubber Powder from Recycled Tire

Assessment of bonding, durability, and low-temperature performance of cement-based rapid patching materials for pavement repair

Laboratory Evaluation of the Use of Cement-Treated Construction and Demolition Materials in Pavement Base and Subbase Applications

Finite Element Analysis and Laboratory Testing for Design of Asphalt Concrete Pavement on Concrete Bridges

Evaluation of cement treatment of reclaimed construction and demolition waste as road bases

PREPARATION AND PERFORMANCE OF CEMENTING MATERIALS FOR RAPID MAINTENANCE OF PAVEMENT POTHOLES

The Effect of Incorporating 100% of Undiluted and Diluted Reclaimed Epoxy Asphalt Materials into Pervious Cement Mixes