Abstract:Abstract Currently, many different aircraft engine types exist. They have a wide range of operating conditions: the flight speed can vary from zero to hypersonic values, the flight altitude from near-earth conditions to space flights. During the flight, loads are not kept constant. Engines have significant dynamic overloads, temperature and pressure differences, can operate in conditions of high humidity or dust, as well as in various aggressive environments. The development of aviation and rocket engine building is associated with a continuous increase in the working thermodynamical cycle parameters. Further improvement of gas turbine engines (GTE) can be carried out in two directions. The first is using new advanced engine designs based on a modernized cycle, with a different fuel, original design, and power scheme. This direction also includes the application of new high-performance elements in the engine: bearings, seals, coatings, etc. The second direction is related to the improvement of existing structures, increasing their efficiency by more detailed working conditions forecasting based on the use of modern computing software systems. This article presents a study of the potential mechanical face gas dynamic seal (FGDS) in the support in an aircraft engine compressor. Aircraft engines are characterized by multi-mode operation and high temperature levels in the internal cavities. For a FGDS operating with a working gap of several microns the exact determination of the deformation value is a very important result of the design process. This article considers the influence of the convective heat transfer coefficients distribution on the value of sealing rings thermal deformations. To achieve this goal, two compaction models were created: the gas-dynamic model for determining the convective heat transfer coefficients in the ANSYS CFX software program; and the structural model for calculating the resulting deformations. Interaction between the models was performed based on a specially created methodology. The obtained results can be used in the design of a FGDS for the supports in the compressors of aircraft engines and power plants.

Spline coupling in the rotor dynamics problems of a gas turbine engine

Analysis of the approaches used for calculating involute splined couplings and the methods of considering their influence on the dynamic behavior of systems

Analytical modeling of the lateral stiffness of a spline coupling considering teeth engagement and influence on rotor dynamics

Extensive Experimental Study on the Stability of Rotor System With Spline Coupling

Dynamic characteristics of rotor system with parallel and angular misaligned involute spline coupling

Involute spline couplings in aero-engine: Predicting nonlinear dynamic response with mass eccentricity

The nonlinear dynamic characteristics of the aero-turboshaft engine rotor blade casing rubbing system with the curvic couplings considering the elastoplastic stage

The prediction of the non-linear dynamics of a squeeze-film damped aero-engine rotor housed in a flexible support structure

Dynamic modeling and analysis of the spline joint-flexible coupling-rotor system with misalignment

Nonlinear Vibration Characteristics of the Involute Spline Coupling in Aeroengine with the Parallel Misalignment

Static and Dynamic Stress of the Combined Rotor with Curvic Couplings Considering the Rough Three-Dimensional Interface at Extreme Operating Conditions

Investigation of Bending Stiffness of Gas Turbine Engine Rotor Flanged Connection

Dynamic Characteristics and Load Coefficient Analysis of Involute Spline Couplings

A Study on the Influence of Nonlinear Vibration on Fretting Damage of Involute Spline Pairs in Aero-Engines

Meshing Force of Misaligned Spline Coupling and the Influence on Rotor System

The influence of nonuniform heat transfer coefficient distribution on the value of thermal deformations in mechanical gas dynamic seal rings

Multi-Fidelity Simulation of Gas Turbine Overall Performance by Directly Coupling High-Fidelity Models of Multiple Rotating Components

Modeling and dynamic analysis for rotors with curvic-coupling looseness

Uncertainty quantification and probabilistic reliability analysis for the self-excited vibration of a spline-shafting system

Nonlinear dynamic analysis of floating involute splines considering comprehensive misalignment

Dynamic modeling of GTF star gear-rotor coupling system considering structural flexibility