VAWT support structure mass sensitivity due to aerodynamic load scaling

Adriana Correia da Silva,Michael Muskulus

DOI: https://doi.org/10.1088/1742-6596/2626/1/012003

2023-10-01

Journal of Physics: Conference Series

Abstract:Abstract The X-rotor wind turbine is an X-shaped hybrid vertical axis wind turbine whose power take-off is done by horizontal axis rotors located at the tip of the lower blades. Based on an initial basic study, the present study developed a preliminary jacket design as the turbine support structure. Steady aerodynamic loads were obtained from an actuator cylinder model and dynamic load simulations including wave loads were performed. The structure was checked according to fatigue damage and maximum yielding for representative site-specific load cases for fatigue and ultimate limit states. Even though the use of a conventional jacket was shown to be feasible for the new turbine concept, the overall mass of the support structure obtained by the higher fidelity model was higher than the initial prediction. The design was driven by the fatigue damage, caused by large cyclical loads on every rotor rotation. The effect of a hypothetical aerodynamic load reduction on the jacket mass was investigated. The developed design methodology was also applied to the design of equivalent jackets after a load reduction of 75% and 50% and the mass of the structure was shown to be sensible, with a respective reduction of 25% and 48%. This result demonstrates that different design strategies that influence the magnitude of the aerodynamic loads (e.g. the control strategy) could lead to a more cost-efficient jacket design.