Abstract:The general frame of the present study falls under the umbrella of ongoing research and innovation in wind energy technology to improve the efficiency and reliability of vertical-axis wind turbines (VAWTs) in terms of design and control. While blade pitching is foreseen as a solution to minimize boundary layer separation and maximize the lift force during the entire cyclic blade operation (effectively enhancing the performances of VAWTs), conclusive research on active blade pitching mechanisms in low wind speed regions is limited because of the 3D complex aerodynamic around VAWT blades. The paper reports a holistic study on active blade pitching solutions to enhance the performance of H-rotor Darrieus VAWTs for different turbine design parameters, i.e., geometrical (different number and airfoil thickness, and solidity) under several operational conditions (Reynolds number ( Re ), and tip speed ratio (TSR)). In this study, a variable blade pitching technique, adapted for periodic variation of the angle of attack , is incorporated in a high-fidelity two-dimensional VAWTs transient Computational Fluid Dynamics (CFD) model to eliminate the dead band of small-scale wind turbines operating at low wind speed regions and increase the performance coefficient Cp at different TSRs. Sliding mesh and remeshing to capture the blade pitching are used to manage the rotor rotation. The CFD model is validated against experimental data from the literature. The results indicate that the local widening of the angle of attack (AoA) for each NACA0015 airfoil produces a Cp of 0.44, which represents 81% enhancement in the Cp at TSR of 1.5. Moreover, the study shows that increasing the number of blades or extending the blade chord length can eliminate the dead band of wind turbines. Furthermore, the maximum possible torque for 3- and 4-bladed rotor designs is achieved using the variable pitching mechanism.

Analysis of VAWT aerodynamics and design using the Actuator Cylinder flow model

Aerodynamic Modeling of Floating Vertical Axis Wind Turbines Using the Actuator Cylinder Flow Method

Experimental Analysis of Vertical Axis Wind Turbine

Analysis of Aerodynamic Characteristics of Vertical Axis Wind Turbine (VAWT) Based on Modified Double Multiple Stream Tube Model

Validation of Actuator Line and Vortex Models Using Normal Forces Measurements of a Straight-Bladed Vertical Axis Wind Turbine

Validation of an Actuator Line Model Coupled to a Dynamic Stall Model for Pitching Motions Characteristic to Vertical Axis Turbines

VAWT support structure mass sensitivity due to aerodynamic load scaling

Performance Analysis of the Blade for the V-Shaped Vertical Axis Wind Turbine

CFD Analysis on Novel Vertical Axis Wind Turbine (VAWT)

Parked and Operating Loads Analysis in the Aerodynamic Design of Multi-megawatt-scale Floating Vertical Axis Wind Turbines

Flow analysis and sensitivity study of vertical-axis wind turbine under variable pitching

Aerodynamic Analysis of a Helical Vertical Axis Wind Turbine

High-Precision Numerical Investigation of a VAWT Starting Process

Validation and accommodation of vortex wake codes for wind turbine design load calculations

Flow characteristics and dynamic responses of a parked straight‐bladed vertical axis wind turbine

Visualization of Aerodynamic Forces and Flow Field on a Straight-Bladed Vertical Axis Wind Turbine by Wind Tunnel Experiments and Panel Method

Structural Analysis of Large-Scale Vertical-Axis Wind Turbines, Part I: Wind Load Simulation

Performance analysis of an idealized Darrieus–Savonius combined vertical axis wind turbine

Development and assessment of an actuator volume method in rotating frame for predicting the flow-field of horizontal-axis wind turbines

Accuracy and Consistency of CFD and Engineering Models for Simulating Vertical Axis Wind Turbine Loads

Multiple Boundary Layer Suction Slots Technique for Performance Improvement of Vertical-Axis Wind Turbines: Conceptual Design and Parametric Analysis