Experimental investigation of thickness profile in an extended meniscus of thin film evaporation using reflectometry

Saumya Singh,Soubhik Kumar Bhaumik,Pawan Kumar Singh
DOI: https://doi.org/10.1016/j.expthermflusci.2023.111069
IF: 3.2
2024-02-01
Experimental Thermal and Fluid Science
Abstract:The transition region encompassing high heat flux dissipation is an intriguing domain and thus draws one's attention to unfold methods of amplifying the heat flux dissipation with experimental facts. The present study is an experimental inquisition of the evaporating thin film in an extended meniscus (adsorbed region and transition region). The following work investigates the shape of the meniscus by measuring its thickness profile using spectral reflectance. The effect of adding nanoparticles (Al2O3) in the base liquid on the extended meniscus shape is compared to the base liquid alone (water). The immediate effect on adsorbed thickness prompted by the suspension of nanoparticles in the base working liquid is addressed. A novel insight into the nanoparticles behaving similarly to the extent of nanoscale roughness in the adsorbed thin film meniscus region has been insinuated as a potential explanation for the observed increase in adsorbed region thickness. The fresh concept drawn here from experimentally observed data is that numerical analysis of computing the thickness of the adsorbed region in the case of nanofluid cannot be the same as without nanofluid under the same operating conditions as claimed in prior numerical investigations in the available literature. Also, a panoramic discussion exploring the curvature profile, pressure profile and the heat transfer is presented. Although the peak in curvature decreases upon the introduction of nanoparticles in water pertaining to the surface roughness effect on the surface, a rise in the peak of curvature profile is achieved when the temperature is increased by supplying heat below the substrate surface. This is owed to thinning of the adsorbed layer which increases the pressure gradient required to pull liquid from the intrinsic meniscus towards transition region for replenishing liquid lost to evaporation.
engineering, mechanical,thermodynamics,physics, fluids & plasmas
What problem does this paper attempt to address?