Abstract:<p>Rock abrasivity is an important factor that affects tool wear and tool parameter design, construction efficiency, and cost budgeting during rock excavation. The Cerchar abrasivity index (CAI) is used as a standard parameter to characterize the abrasiveness of rocks. It can be obtained through the Cerchar abrasivity test in a laboratory. However, conventional laboratory Cerchar abrasivity tests and petrophysical and mechanical tests are associated with certain problems, such as long cycles, high costs, and measurement delays, which cannot serve the determination of rock abrasiveness in field. Digital drilling technology is an efficient in situ test method that can effectively link drilling parameters with rock properties. Based on the test results for the CAI and physical and mechanical properties of 13 groups of rock samples collected from southwestern China, this paper focuses on the correlations of the CAI value with rock strength, petrographic characteristics and drilling parameters. By adopting a flat bottom diamond bit that mainly relies on grinding, according to the principle of mechanical balance and energy conservation during rock drilling, the grinding energy per unit volume of rock (ηe) is defined and derived. The univariate regression analysis results show that the uniaxial compressive strength (UCS) and equivalent quartz content (EQC) are the most important factors for explaining CAI and that the CAI can be well estimated using the ηe. Additionally, two optimal regression models for predicting CAI were established using stepwise multiple regression analysis. UCS and ηe were introduced into the model, and the use of both can predict approximately 96% of the variance in the CAI. In addition, a performance evaluation of the models proposed in this paper and previously published CAI prediction models that the prediction models established in this paper are verify statistically more reasonable and reliable than the previously proposed models. The research methods and results provide a new method for the rapid and accurate determination of rock abrasiveness in engineering field.</p>

Measurement, prediction, and modeling of the drilling specific energy by soft rock properties during the drilling operation

Strength prediction and drillability identification for rock based on measurement while drilling parameters

Real Time Optimization of Drilling Operations and Performance Based on Drilling Specific Energy Determined from Actual Field Data

A smart look at monitoring while drilling (MWD) and optimizing using acoustic emission technique (AET)

Performance analysis of drilling machines based on rock properties and machine's specifications

Experimental study of the effect of cooling/lubricating fluids on penetration rate in hard and soft rock drilling process

An experimental investigation into the borehole drilling and strata characteristics

Real-time rock strength determination based on rock drillability index and drilling specific energy: an experimental study

Measurement while core drilling based on a small-scale drilling platform: Mechanical and energy analysis

Development of Monitoring and Forecasting Technology Energy Efficiency of Well Drilling Using Mechanical Specific Energy

Evaluation and optimization of drilling efficiency while drilling based on improved rock-breaking specific energy model of bit

Multiple regression model for prediction of rock properties using acoustic frequency during core drilling operations

Accurate determination of drilling parameters in time series for estimate of rock strengths

Experimental study on predicting rock properties using sound level characteristics along the borehole during drilling

Drilling Process Monitoring for Predicting Mechanical Properties of Jointed Rock Mass: A Review

Estimation of Optimal Drilling Efficiency and Rock Strength by Using Controllable Drilling Parameters in Rotary Non-Percussive Drilling

Efficiency evaluation of a percussive drill rig using rate-energy ratio based on rock drilling tests

New approach for prediction of specific energy using sound levels produced during core drilling operations

Investigation on the relationship among the Cerchar abrasivity index, drilling parameters and physical and mechanical properties of the rock

Determining Method of Tensile Strength of Rock Based on Friction Characteristics in the Drilling Process

Rock Strength Determination Based on Rock Drillability Index and Drilling Specific Energy: Numerical Simulation Using Discrete Element Method