Abstract:Porous biomaterials based on triply periodic minimal surfaces (TPMS) are intensely studied and discussed in the literature. Manufacturing of these structures with a complex geometry became possible using additive manufacturing methods, having their own specifics and challenges. Previously, we demonstrated that sheet-based gyroids, one of TPMS structures, manufactured by electron beam powder bed fusion in Melt and Wafer themes could possess identical mechanical properties (quasi-elastic gradient). In the current research sheet-based gyroids were produced using Wafer Theme with five different settings, including electron beam current and scan speed variation with MultiBeam turned on and off, in attempt to obtain thin walls without losing mechanical performance. Mechanical tests revealed that the specimens manufactured with higher beam line energy on average show better mechanical properties. The specimens produced with MultiBeam showed slightly lower mechanical properties, and do not demonstrate significant improvement in the TPMS surface roughness. According to SEM studies, the average wall thickness was about 0.4 mm for specimens with high line energy, and 0.3 mm for low line energy. Through-hole defects on the horizontal surfaces, noticed and discussed by us previously, have larger average area of the hole and more irregular shape for increased beam line energy. TPMS surface morphology of the specimens produced with higher beam energy and no MultiBeam was on average more even. According to EBSD, α/α` martensite with laths oriented in a Widmanstätten basket-weave pattern was observed with no β phase in the resulting material. No significant differences in microstructure between specimens produced with different beam energy was detected. FEA modeling revealed the impact of the wall thickness, through holes size and orientation on quasi-elastic gradient of a gyroid. It was demonstrated that, through holes with small size located on the horizontal surfaces (layer plane) have only a minor impact on the mechanical properties of the samples if they are not extremely abundant.

Evaluation of the mechanical behavior of 3D printed cellular metamaterials with special geometries

Effective mechanical properties of additive manufactured triply periodic minimal surfaces: experimental and finite element study

Compression behavior of sheet-network triply periodic minimal surface metamaterials as a function of density grading

Evaluation of energy absorption capabilities and mechanical properties in FDM printed PLA TPMS structures

Prediction of Cellular Structure Mechanical Properties with the Geometry of Triply Periodic Minimal Surfaces (TPMS)

Compression and resilient behavior of graded triply periodic minimal surface structures with soft materials fabricated by fused filament fabrication

Energy absorption characteristics of metallic triply periodic minimal surface sheet structures under compressive loading

Compressive behavior of selective laser melting printed Gyroid structures under dynamic loading

Quasi-static and dynamic compressive behaviour of sheet TPMS cellular structures

Expanding manufacturability of sheet-based triply periodic minimal surfaces by electron beam powder bed fusion in Wafer theme

Novel triply periodic minimal surfaces sandwich structures: Mechanical performance and failure analysis

3D Printing of Flexible Mechanical Metamaterials: Synergistic Design of Process and Geometric Parameters

The Influence of the Structure Parameters on the Mechanical Properties of Cylindrically Mapped Gyroid TPMS Fabricated by Selective Laser Melting with 316L Stainless Steel Powder

Mechanical Behaviour of Photopolymer Cell-Size Graded Triply Periodic Minimal Surface Structures at Different Deformation Rates

Design, Fabrication, and Characterization of 3D-Printed Multiphase Scaffolds Based on Triply Periodic Minimal Surfaces

Compression Performance and Failure Analysis of 3D-Printed Carbon Fiber/PLA Composite TPMS Lattice Structures

Compressive properties of parametrically optimised mechanical metamaterials based on 3D projections of 4D geometries

Energy Absorption and Deformation Behavior of 3D Printed Triply Periodic Minimal Surface Stainless Steel Cellular Structures under Compression

Investigating internal architecture effect in plastic deformation and failure for TPMS-based scaffolds using simulation methods and experimental procedure

Investigation of Energy Absorbing Characteristics and Damage Mechanisms of Triply Periodic Minimal Surface Structures fabricated by Powder Bed Fusion Technology

Compression behavior of 4D printed metamaterials with various Poisson's ratios