Abstract:The 20kt Liquid Scintillator (LS) JUNO detector is being constructed by the International Collaboration in China, with the primary goal of addressing the question of neutrino mass ordering (hierarchy). The main challenge for JUNO is to achieve a record energy resolution, ~3% at 1MeV of energy released in the LS, which is required to perform the neutrino mass hierarchy determination. About 20 000 large 20-inch PMTs with high Photon Detection Efficiency (PDE) and good photocathode uniformity will ensure an approximately 80% surface coverage of the JUNO detector. The JUNO collaboration is preparing equipment for the mass tests of all PMTs using 4 dedicated containers. This approach allows us to test 144 PMTs in parallel. The primary measurement in the container will be the PMT response to illumination of its photocathode by a low-intensity uniform light. Each of the 20 000 PMTs will undergo the container test. Additionally, a dedicated scanning system was constructed for sampled tests of PMTs that allows us to study the variation of the PDE over the entire PMT photocathode surface. The core of the scanning station is a rotating frame with 7 LED sources of calibrated short light flashes that are placed along the photocathode surface covering zenith angles from the top of a PMT to its equator. The collection efficiency of a large PMT is known to be very sensitive to the Earth Magnetic Field (EMF), therefore, understanding the necessary level of EMF suppression is crucial for the JUNO Experiment. A dark room with Helmholtz coils compensating the EMF components is available for these tests at a JUNO facility. The Hamamatsu R12860 20-inch PMT is a candidate for the JUNO experiment. In this article the container design and mass-testing method, the scanning setup and scanning method are briefly described and preliminary results for performance test of this PMT are reported.

Photocathode-Uniformity Tests of the Hamamatsu R5912 Photomultiplier Tubes Used in the Milagro Experiment

Characterization of the Hamamatsu R11780 12 inch Photomultiplier Tube

Acceptance tests of Hamamatsu R7081 photomultiplier tubes

Results from the Milagrito Experiment

A New Compact Position-Sensitive PMT for Scintillation Detectors

Characterization of the Hamamatsu 8-inch R14688-100 PMT

Development and Characterization of Sub-100 Ps Photomultiplier Tubes.

Irradiation study of UV Silicon Photomultipliers for the Mu2e Calorimeter

Large photocathode 20-inch PMT testing methods for the JUNO experiment

An Ultra-Low Background PMT for Liquid Xenon Detectors

Radiation Hardness tests with neutron flux on different Silicon photomultiplier devices

Response of photomultiplier tubes to xenon scintillation light

Detailed investigations of PMTs in optical sensors for neutrino telescopes such as IceCube Upgrade

Development of Low Radioactivity Photomultiplier Tubes for the XMASS-I Detector

A photomultiplier tube test stand and on-site measurements to characterise the performance of Photonis XP3062 photomultiplier tubes at increased background light conditions and lower gain

Acceptance Tests of more than 10 000 Photomultiplier Tubes for the multi-PMT Digital Optical Modules of the IceCube Upgrade

Characterisation of the Temperature-dependent Dark Rate of Hamamatsu R7081-100 10" Photomultiplier Tubes

Replacement of a Photomultiplier Tube with Silicon Photomultipliers for use in Safeguards Applications

Neutron irradiation test of Hamamatsu, SensL and AdvanSiD UV-extended SiPMs

A study of the new hemispherical 9-inch PMT