Abstract:It has been long understood that fretting differs from sliding wear in that the relative displacement between the bodies is generally smaller than the size of the contact between them, with debris ejection from the contact thus playing an important role in the behaviour of the contact in fretting. Whilst these ideas were clearly articulated more than 30 years ago via Godet's third-body approach and Berthier's concept of the tribology circuit, calculation of wear rates in fretting have continued to employ Archard's wear equation (or approaches directly derived from it), despite this approach assuming that the rate of wear is controlled by the rate of generation of wear debris (as opposed to the rate of its ejection from the contact). It has been shown recently that when debris ejection is the rate-determining-process in fretting, the instantaneous rate of wear is inversely proportional to a characteristic dimension of the wear scar. When non-conforming specimen pair geometries (such as cylinder-on-flat) are employed in fretting testing, the wear scar size increases as wear proceeds, and thus the instantaneous rate of wear decreases. In this paper, wear equations have been derived for three commonly employed non-conforming pair specimen geometries, which all take the form <math>Vw=KRn−1Edn</math> (<math>Vw</math> is the wear scar volume, <math>R</math> is the radius of the non-plane specimen(s) in the pair and <math>Ed</math> is the frictional energy dissipated) where <math>n</math> varies between 0.67 and 0.8 depending upon the geometry and assumptions made regarding the governing equation. It is argued that the assumptions on which the analysis is based are most valid for the cylinder-on-flat contact configuration with fretting perpendicular to the cylinder axis where the length of the line contact is large compared to the wear scar width. It is demonstrated that, despite the often apparently good fit of experimental data to an Archard-type equation, it is not appropriate to employ such Archard-type approaches to the analysis of fretting data in situations where debris ejection is the rate-determining-process. The equations derived in this paper relating wear scar size to some measure of the duration of the test should be used for such analysis instead of the linear relationships generally employed in previous work.

Effects of Fretting Wear on Rolling Contact Fatigue

A continuum damage mechanics finite element model for investigating effects of surface roughness on rolling contact fatigue

Effect of spatial hardness distribution in rolling contact fatigue performance of bearing contacts

The effect of friction on surface crack initiation in rolling contact fatigue considering damage accumulation

Investigation into Rolling Contact Fatigue Performance of Aerospace Bearing Steels

Finite element analysis of fretting wear considering variable coefficient of friction

A Debris Layer Evolution-Based Model for Predicting Both Fretting Wear and Fretting Fatigue Lifetime

Experimental Study of the Effects of Surface Defects on Rolling Contact Fatigue Behavior

Finite Element Analysis Simulation of the Effect of Induction Hardening on Rolling Contact Fatigue

Fretting Fatigue Life Model Under Combined Loading

Simulation of fretting wear in steel wires under variable coefficient of friction and variable wear coefficient

Fretting Wear Behavior of Fluorine Rubber and Short Carbon Fiber Reinforced Fluorine Rubber Matrix Composites

Experimental and finite element analysis for evaluating influence of contact pressure on fretting fatigue mechanisms of A319‐T6 cast aluminum alloy

Contact fatigue life prediction of a bevel gear under spectrum loading

Experimental and numerical study on the fretting wear-fatigue interaction evolution in press-fitted axles

Contact size and debris ejection in fretting: The inappropriate use of Archard-type analysis of wear data and the development of alternative wear equations for commonly employed non-conforming specimen pair geometries

Cyclic Constitutive Response and Effective S–N Diagram of M50 NiL Case-Hardened Bearing Steel Subjected to Rolling Contact Fatigue

Effect of shot peening parameters on fretting fatigue lifetime

Experimental and numerical study on press-fitted railway axles: Competition between fretting and plain fatigue

The effect of retained austenite on rolling/sliding contact fatigue of high carbon steel

Electrical contact resistance endurance of AgNi10 alloys under fretting wear: Experiment and numerical prediction