Abstract:A greener, cleaner cement called geopolymer has recently been developed instead of Portland cement as a grouting material, with improved grout properties and reduced carbon dioxide emissions. Nevertheless, the investigation of geopolymer's rheological and viscoelastic characteristics is still inadequate for grouting materials. Therefore, in this paper, the rheological and viscoelastic properties of geopolymer grouting material (GGM) with different content of fly ash (FA), slag (SL), and silica fume (SF) are studied. It is concluded that for the shear stress with a fixed shear rate (100 s−1), using 20 %–30% SL to replace FA significantly partially increases the shear stress of FA-based GGM. Further use of 20 %–30% SF to partially replace SL reduces the shear stress of FA/SL-based GGM. The yield stress and plastic viscosity of GGM present similar trends with the shear stress. In contrast, the slump spread shows a change rule contrary to the above parameters. The static rheological behavior of all GGMs fits a Bingham model regardless of the time and mixture. An approximate linear decline of storage modulus (G′) was detected in the frequency sweep test, indicating the pseudoplastic dynamic rheological behavior of GGMs under the oscillatory shearing. The yield stresses of GGM with FA, SL, and SF are decreased over time under shearing load. These results signify that GGM with FA, SL, and SF can quickly recover good workability after retempering. SL and SF increase the G′ of GGM due to higher chemical adhesion and specific surface area, respectively, as evident from the amplitude sweep test. Using 20 %–30% SF to replace SL partially rose the peak G′ significantly and lowered the decline slopes of the G′ curve in the frequency sweep test. The fluctuation of G′ cure is also remitted considerably by the inclusion of SF. Calorimetric and Fourier Transform Infrared Spectroscopy (FTIR) tests revealed the quick generation of C-(A)-S-H, leading to the poor flowability of GGM with FA and SL. The rapid dissolution of SF increases the modulus of the activator and reduces the basicity of the activator, leading to the results of using SF to improve the flowability of GGM with FA and SL. The study indicates that geopolymer is suitable for using grouting material instead of Portland cement paste. Different combinations of FA, SL, and SF can be used to modify the flowability of GGM.

Assessment of recycling use of GFRP powder as replacement of fly ash in geopolymer paste and concrete at ambient and high temperatures

Study on Modification of Geopolymer Based on Recycled Concrete Fine Powder

Synthesis of Geopolymers Using Municipal Solid Waste Incineration Fly Ash and Construction and Demolition Waste: Mechanical and Thermal Activation

Recycling of red mud and flue gas residues in geopolymer aggregates (GPA) for sustainable concrete

Effect of Waste Glass Powder and Bamboo Fiber on the Physico-Mechanical Properties and High-Temperature Behavior of a Fly Ash-Based Geopolymer

Fully Recycled Engineered Geopolymer Composite: Mechanical Properties and Sustainability Assessment

Determining engineering properties of ultra-high-performance fiber-reinforced geopolymer concrete modified with different waste materials

Properties of fresh and hardened fly ash/slag based geopolymer concrete: A review

Effect of Glass Fiber-Reinforced Plastic Waste on the Mechanical Properties of Concrete and Evaluation of Its Feasibility for Reuse in Concrete Applications

Properties of Geopolymer Mixtures Incorporating Recycled Ceramic Fines

Effect of All-Component Recycled GFRP on Physical-Mechanical Properties and Microstructures of Concrete

Study on the Effect of Recycled Fine Aggregate Qualities on Fly Ash/GGBS-Based Geopolymer Mortar

Waste Valorization: Sustainable Geopolymer Production Using Recycled Glass and Fly Ash at Ambient Temperature

Utilization of Fly Ash to Enhance Ground Waste Concrete-Based Geopolymer

Synthesis Of Fly Ash/Metakaolin Geopolymer For Concrete Retrofitting Application

Utilization of OPC and FA to enhance reclaimed lime-fly ash macadam based geopolymers cured at ambient temperature

Rheological and Viscoelastic Characterizations of Fly Ash/slag/silica Fume-Based Geopolymer

The Use of Recycled Aggregate Sludge for the Preparation of GGBFS and Fly Ash Based Geopolymer

Utilizing waste geopolymer powder as partial cement replacement for sustainable cement mortar: Micro-macro properties and modification

A Review on Fresh, Hardened, and Microstructural Properties of Fibre-Reinforced Geopolymer Concrete

Compressive strength of fly ash based geopolymer utilizing waste completely decomposed granite