Abstract:The incorporation of construction and demolition (C&D) waste in concrete production has gained great importance toward sustainability, especially in geopolymer concrete. In this study, ground granulated blast-furnace slag (GGBFS) and fine aggregate of normal geopolymer concrete were partially replaced by clay brick powder (CBP) and fine clay brick (FCB) derived from C&D waste, respectively, aiming to produce high-strength geopolymer concrete (HSGC). Fly ash (FA) was also used as a partial replacement for GGBFS in normal geopolymer concrete. Twenty HSGC mixtures were designed using the response surface methodology with three variables, including CBP (0–25%), FA (0–25%), and FCB (0–50%). The performance of the proposed HSGC mixtures was assessed by measuring several mechanical and durability properties. In addition, a variety of physicochemical methods, including X-ray fluorescence spectroscopy, X-ray diffraction, and scanning electron microscopy, were used to examine the mineralogical and microstructural characteristics of the control and the developed mixtures. The findings revealed that the compressive, splitting tensile, and flexural strengths of the HSGC made with C&D waste ranged from 38.0 to 70.3 MPa, 4.1 to 8.2 MPa, and 5.2 to 10.0 MPa, respectively. The results also indicated that the incorporation of FA is an essential parameter to eliminate the negative impacts of C&D waste addition on concrete workability. The optimal proportions for the HSGC were 5% for CBP, 5% for FA, and 40% for FCB, which were determined to generate the optimized HSGC with the highest mechanical performance, according to the verified models and optimization findings. The physicochemical analyses showed that the thick amorphous geopolymeric gel predominated the nonporous structure of the optimized HSGC, which had good mechanical characteristics. Furthermore, the anti-carbonation performance and freezing resistance of the optimal HSGC increased by 17.7% and 14.6%, respectively, while the apparent porosity decreased by 8.4%.

Experimental Study on Characteristics of Fly Ash–GGBS-Based Geopolymer Concrete with Demolition Waste as Fine Aggregate

Durability, Microstructure, and Optimization of High-Strength Geopolymer Concrete Incorporating Construction and Demolition Waste

Effect of Iron Ore Tailings and High Magnesium Nickel Slag on Flyash - Ggbs Based Geopolymer Concrete (GPC)

Properties of fresh and hardened fly ash/slag based geopolymer concrete: A review

Life Cycle Assessment and Impact Correlation Analysis of Fly Ash Geopolymer Concrete

Synthesis of Geopolymers Using Municipal Solid Waste Incineration Fly Ash and Construction and Demolition Waste: Mechanical and Thermal Activation

Mechanical, durability and microstructural assessment of geopolymer concrete incorporating fine granite waste powder

Mechanical properties of fly ash based geopolymer concrete using only steel slag as aggregate

Determining engineering properties of ultra-high-performance fiber-reinforced geopolymer concrete modified with different waste materials

Low-carbon enhancement of fly ash geopolymer concrete: Lateral deformation, microstructure evolution and environmental impact

Chemical stabilization of demolition wastes in pavement bases using one–part fly ash and slag based geopolymers

The Use of Recycled Aggregate Sludge for the Preparation of GGBFS and Fly Ash Based Geopolymer

Development of Geopolymer Foam Concrete Incorporating Sugarcane Bagasse Ash and Fly Ash; 100% Recycled and Cement-Less Concrete

Mix design of FA-GGBS based lightweight geopolymer concrete incorporating sintered fly ash aggregate as coarse aggregate

Nigerian Families Sue Pfizer, Testing the Reach of U.S. Law

Experimental Study on Fabrication of Environment-Friendly Concrete by Solidifying Aeolian Sand and Natural Gravel with Fly Ash-Based Geopolymer

Waste Valorization: Sustainable Geopolymer Production Using Recycled Glass and Fly Ash at Ambient Temperature

Use of Waste Glass Powder toward more Sustainable Geopolymer Concrete

Up-scaling of fly ash-based geopolymer concrete to investigate the binary effect of locally available metakaolin with fly ash

Study on the Effect of Recycled Fine Aggregate Qualities on Fly Ash/GGBS-Based Geopolymer Mortar

Assessment of recycling use of GFRP powder as replacement of fly ash in geopolymer paste and concrete at ambient and high temperatures