Comparative analysis of different methods in estimating wind speed distribution, and evaluation of large‐scale wind turbine performance in Rahva‐Bitlis, Turkey

Faruk Oral
DOI: https://doi.org/10.1049/rpg2.12898
IF: 3.034
2023-12-08
IET Renewable Power Generation
Abstract:The probability density function curves obtained from the WindPRO program with the Weibull and Rayleigh distributions are given in Figure 8, along with the observed data. According to the figure, it is seen that the results of Weibull and WindPRO are closer to the observed data. In this study, wind characteristics and electricity generation potential from wind energy were investigated in the Bitlis‐Rahva region in eastern Turkey. Ten‐minute wind data from the Bitlis meteorological station were used in the study. The determination of the wind speed (WS) distribution was carried out using the WindPRO program together with the Weibull and Rayleigh distributions. R2, RMSE, and χ2 goodness‐of‐fit tests were used to measure the accuracy of the velocity distribution process. A digital elevation model of the power generation site was created to evaluate wind data and predict turbine performance. Wind power generation performance was evaluated using five different wind turbines (WTs). A power curve model was developed for the WTs to determine the capacity for energy generation. According to the error tests, it has been determined that the results obtained with the WindPRO program can represent the observed wind data most accurately. The results from the WindPRO program analysis showed an average annual WS of 3.26 m/s and a power density of 49.77 W/m2. Increasing height was found to increase WS and power density. The prevailing wind direction was found to be South‐Southwest with a frequency value of 27.5%. The largest capacity factor was obtained from the WT with the largest rotor diameter and rated power. Out of all the WTs examined, the turbine with the largest rated power and rotor diameter produced the greatest amount of energy. According to the capacity factor values calculated for the selected WTs, the region is not considered efficient for wind energy investments. However, as WS and power density increase with increasing altitude, it is thought that different higher parts of the region may be more efficient in terms of wind energy utilization.
energy & fuels,engineering, electrical & electronic,green & sustainable science & technology
What problem does this paper attempt to address?