Oxidations carried out by means of vanadium oxide catalysts

P. Mars,D.W. van Krevelen
DOI: https://doi.org/10.1016/s0009-2509(54)80005-4
IF: 4.7
1954-01-01
Chemical Engineering Science
Abstract:All technically interesting reactions carried out with vanadium oxide catalysts are marked by their highly exothermic character, which forms an impediment to the investigation of the kinetics of these processes. In the present study use was made of a fluid bed, in which the temperature is uniform. The oxidation of the following substances: benzene, toluene, naphthalene, and anthracene has been studied.The partial pressures of the reacting substances were varied to the greatest possible extent. Both reaction components appeared to influence the reaction rate. A formula depicting this influence is derived. This formula may be interpreted by assuming two successive reactions, namely the reaction between the aromatic and the oxygen on the surface, and the re-oxidation of the partly reduced surface by means of oxygen.The formula may be reduced to an equation by which also the data on the oxidation of sulphur dioxide by means of vanadium oxide catalysts found in the literature are well described.Using kinetic data it is possible to determine the optimum temperature distribution in a fixed bed reactor used for the oxidation of sulphur dioxide and to make calculations of the ratio between the amounts of catalyst to be used in the various stages of a multiple-stage reactor. The results of these calculations have been compared with practical experience.
engineering, chemical
What problem does this paper attempt to address?