Charge–spin conversion in Pt 1− x Bi x alloys for spin–orbit torque switching

Zhendong Chi,Yong-Chang Lau,Masashi Kawaguchi,Masamitsu Hayashi
DOI: https://doi.org/10.1063/5.0052534
IF: 6.6351
2021-06-01
APL Materials
Abstract:We have studied the spin torque efficiency of Pt<sub>1−<i>x</i></sub>Bi<sub><i>x</i></sub>/Co based heterostructures for spin–orbit torque (SOT) switching devices. While the field-like component of the SOT shows a relatively small change with the Bi concentration (<i>x</i>), the damping-like component (<i>ξ</i><sub>DL</sub>) abruptly increases with increasing <i>x</i>. The increase in <i>ξ</i><sub>DL</sub> with <i>x</i> is largely associated with the change in the Pt<sub>1−<i>x</i></sub>Bi<sub><i>x</i></sub> layer resistivity (<i>ρ</i><sub><i>xx</i></sub>). The spin Hall conductivity (<i>σ</i><sub>SH</sub>) estimated from <i>ξ</i><sub>DL</sub> and <i>ρ</i><sub><i>xx</i></sub> remains nearly constant at ∼830 (<i>ℏ</i>/<i>e</i>) Ω<sup>−1</sup> cm<sup>−1</sup> for 0 &lt; <i>x</i> ≲ 0.6. Further substitution of Bi results in the formation of PtBi<sub>2</sub>, which causes smaller <i>σ</i><sub>SH</sub> than that of alloys with smaller <i>x</i>. The magnetic easy axis of a 0.6 nm thick Co layer points along the film normal when <i>x</i> is smaller than ∼0.7. Exploiting these characteristics, we show current-induced magnetization switching in the heterostructures. The efficiency to switch a perpendicularly magnetized Co layer is the largest when <i>x</i> ∼ 0.5. These results demonstrate the potential of Pt<sub>1−<i>x</i></sub>Bi<sub><i>x</i></sub> alloys for spin–orbit torque magnetization switching devices.
materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology
What problem does this paper attempt to address?