Abstract:Modular bridge expansion joints (MBEJs) are commonly used in bridges and are often subjected to fatigue damages, which necessitate fatigue monitoring of MBEJs to ensure the reliable operation of the bridges. In this paper, a stress wave based active sensing approach using piezoceramic transducers is developed to monitor the fatigue damage of MBEJ. A MBEJ involves mainly center beam, edge beam, support bar, support box, sliding bearing, sliding spring, elastomeric strip seal, full-penetration weld and reinforcing plate. In practice, for a MBEJ, the part that is most prone to fatigue damage is the full-penetration weld between the center beam and the support bar. In this paper, a specimen, which is the full-scale center-beam/support-bar (CB/SB) assembly, was designed and fabricated to facilitate the experimental study. The assembly mainly includes center beam, support bar, reinforcing plate, and full-penetration weld. The lead zirconate titanate (PZT) transducer bonded on the support bar was used as the actuator and the PZT transducer mounted on the center beam was as the sensor. Dial indicators were utilized to measure the vertical displacement of the center beam. Two series of tests, including static test, and fatigue test, were performed on the specimen in an alternating fashion. Based on the number of cyclic loading, the experiment was divided into six different stages: 0th cycle (the healthy state), 0.8 million cycles, 1.6 million cycles, 2.4 million cycles, 3.2 million cycles, and 4 million cycles. The signals received by the PZT sensor were analyzed with the help of wavelet packet analysis. In addition, the structure stiffness also was considered as a comparative approach in this paper. Experimental results show that during the fatigue test, the structure stiffness decreases with the number of cycle loading. However, the method can only obtain the fatigue damage impact on the entire structure, and cannot determine the fatigue damage degree of a certain weld. On the other hand, the proposed method can accurately monitor the fatigue damage degree of full-penetration welds. The research results show that the developed piezoceramic enabled active sensing approach can monitor and estimate the fatigue damage in MBEJ in real-time.

Experimental study on the damage identification of bridge expansion joints

Experimental Study of Bridge Expansion Joint Damage Based on Natural Frequency

Damage Identification of Multi-Box Steel-Concrete Composite Bridges Based on Modal Curvature Difference Method

Damage Identification Analysis of Bridge Beam with Spaced Supports As Quasi-Periodic Structure

Sound Damage Detection of Bridge Expansion Joints Using a Support Vector Data Description

Vibration-Based Damage Detection Of Cable-Stayed Bridges

Research on damage identification of simply supported bridge based on effect size method for vehicle-bridge coupled vibration

Review of Vibration-Based Damage Detection and Condition Assessment of Bridge Structures Using Structural Health Monitoring

Damage Identification Method for Medium- and Small-Span Bridges Based on Macro-Strain Data under Vehicle-Bridge Coupling

Damage identification of main girders for long span cable-stayed bridge based on flexibility matrix

Damage detection method for structures based on the relative variation of wavelet total energy

Marginal Hilbert spectrum and instantaneous phase difference as total damage indicators in bridges under operational traffic loads

A Novel Mode Sharp-Based Damage Detection Method of Large-Span Bridges

Non-modal vibration-based methods for bridge damage identification

Experimental Investigation and Damage Identification of High-Pile Wharf Framed Bents under Horizontal Impact Loads

Damage Assessment Using The Energy Dissipation Ratio Of Acceleration Signals

Bridge damage detection from the equivalent damage load by multitype measurements

A Spectrum Correlation Matrix-Based Rapid Damage Identification Method for Joints in Hinged Slab Bridges by Sparse Measurement

Monitoring Fatigue Damage of Modular Bridge Expansion Joints Using Piezoceramic Transducers

Bridge damage identification with improved HHT and PSD sensitivity method based on vehicle response