Abstract:Carbon corrosion has been widely documented in electrochemical systems such as fuel cells and water electrolyzers. In these systems, CO2 is neither a reactant or a product, and CO2 produced from carbon corrosion can be directly measured and attributed to the carbon corrosion process. In CO2 electrolysis, the CO2 feed masks the detection of CO2 produced from anodic carbon corrosion, making the quantification of carbon corrosion difficult. Additionally, current CO2 electrolysis systems operate in a different chemical environment than fuel cells and water electrolysis systems, often employing a carbonate-based anolyte. Understanding and quantifying failure modes is critical for the commercialization of CO2 electrolysis, where a durability of multiple years is required. However, at present, many published studies employ carbon-based materials on the anode. These carbon-based anodes may corrode and deteriorate under the oxidative potentials present on the anode under normal CO2 electrolysis operation. Carbon corrosion at the anode may also be convoluted with other common degradation mechanisms, making quantification of specific degradation pathways more challenging. Here, we have developed an ex-situ carbon corrosion test for CO2 electrolysis that allows for the quantification of mass loss from carbon corrosion. Using this test, significant carbon corrosion has been quantified at realistic anodic voltages experienced in operating CO2 electrolysis cells. Based on these results, and informed from the past experiences in the development of fuel cell and water electrolysis systems, we provide a perspective on the use of carbon-based materials on the anode of CO2 electrolysis systems. The CO2 utilization community would benefit from rapidly transitioning away from the use of carbon-based materials on the anode of CO2 electrolysis systems. If carbon materials are used on the anode in CO2 electrolysis systems, it is only appropriate for short-term (<100 h) experiments.

Dynamic vs. Stationary Analysis of Electrochemical Carbon Dioxide Reduction: Profound Differences in Local States

Understanding Trends in Electrochemical Carbon Dioxide Reduction Rates

Molecular Level Insights on the Pulsed Electrochemical CO2 Reduction

Dynamics of the Boundary Layer in Pulsed CO2 Electrolysis

Resolving local reaction environment toward an optimized CO2-to-CO conversion performance

Insights into the Carbon Balance for CO2 Electroreduction on Cu using Gas Diffusion Electrode Reactor Designs

Spatio‐Temporal Electrowetting and Reaction Monitoring in Microfluidic Gas Diffusion Electrode Elucidates Mass Transport Limitations

The dynamic behaviors of heterogeneous interfaces in electrocatalytic CO 2 reduction

Electrode and cell design for CO2 reduction: A viewpoint

Nonidealities in CO2 Electroreduction Mechanisms Revealed by Automation-Assisted Kinetic Analysis

Multiscale simulation on electrochemical CO2 reduction in gas-diffusion-electrode-based flow electrolyzer

Double layer charging driven carbon dioxide adsorption limits the rate of electrochemical carbon dioxide reduction on Gold

Best Practices and Common Pitfalls in Experimental Investigation of Electrochemical CO 2 Reduction at Gas Diffusion Electrodes

Pulsing the Applied Potential in Electrochemical CO 2 Reduction Enhances the C 2 Activity by Modulating the Dynamic Competitive Binding of CO and H

In Situ/Operando Characterization Techniques of Electrochemical CO2 Reduction

Electroreduction of CO2 over Ag: A Multiscale Simulation

Kinetic analysis makes the impossible possible: measuring CO adsorption free energies on the active sites during CO2 electroreduction

Carbon Corrosion in Low-Temperature CO2 Electrolysis Systems

Real Time Analysis of the CO2 Reduction Reaction Products in a Cu-Gde Setup

In-Situ Estimation of Near Electrode Ph During the Electrochemical Reduction of CO2 Using Attenuated Total Reflectance Surface Enhanced Infrared Absorption Spectroscopy

Local Reaction Environment Deviations within Gas Diffusion Electrode Pores for CO 2 Electrolysis