Abstract:The purpose of the Hydracer project is to discuss the system performance of the EHAs (Electro-Hydrostatic Actuators) when integrated into robotic systems. We have developed EHAs focusing on compactness, light-weight, force controllability, and back-drivability. The requirements such as compactness and light-weight lead us to the adoption of high-pressure, which unfortunately contradicts with the other requirements, namely, force controllability and back-drivability. The contradiction indicates the necessity of study to find the balanced specification between them, which was the question we raised when we started the development of Hydracer, a 6-DOF manipulator driven by EHAs. The system design started following the specifications of an industrial standard of small-size manipulators. In the previous paper, we reported on the design and evaluation of actuators, namely, the linear EHA modules for the first three joints from the base and the ceramic-reinforced vane motors for the last three. We could also discuss the preliminary results of force control of the last three (wrist) joints. In this paper, we report on the performance of force-controllability and backdrivability of the first three joints of the manipulator after integrating force controllers and gravity compensation. It provides useful information about the total performance of manipulators driven by EHAs. The RMSEs (root mean square errors) of torques of the first three joints under the gravity compensation were 0.53, 1,7, and 1.2 Nm respectively, while the manipulator could carry 10 kg payload at the horizontally stretched configuration for 5 s.

Development of compact revolute electro-hydrostatic actuator module and evaluation of its backdrivability and internal leakage

Compact, backdrivable, and efficient design of linear electro-hydrostatic actuator module

Design and Control of an Electrohydraulic Soft Actuator System for Robotic Grippers

Lightweight Electrohydrostatic Actuator Drive Solution for Exoskeleton Robots

Study of the Dynamic Properties of the Miniature Electro-Hydrostatic Actuator

Development of an Ε-Type Actuator for Enhancing High-Speed Electro-Pneumatic Ejector Valve Performance

Development of 6-DOF manipulator driven by ceramics reinforced hydrostatic actuators and its experimental evaluations on force control and payload abilities

Development of A Novel Compact Hydraulic Power Unit for the Exoskeleton Robot

Fault-Tolerant Brushless DC Motor Drive for Electro-Hydrostatic Actuation System in Aerospace Application

A 5-Phase Fault-Tolerant Brushless Permanent Magnet Motor Drive for an Aircraft Thin Wing Surface Actuator

Development and Control of an Electro-Hydraulic Actuator System for an Exoskeleton Robot

A New Electric Hydraulic Actuator Adopted the Variable Displacement Pump

AC-Driven Series Elastic Electrohydraulic Actuator for Stable and Smooth Displacement Output

A review of high-speed electro-hydrostatic actuator pumps in aerospace applications: Challenges and solutions

One Novel Hydraulic Actuating System for the Lower-Body Exoskeleton

Load-Sensing Pump Design To Reduce Heat Generation Of Electro-Hydrostatic Actuator Systems

Design of an Actuator for Biped Robots Based on the Axial Flux Motor.

Modeling and Control of a Novel Electro-Hydrostatic Actuator with a Three-Ports Hydraulic Pump

Design and Tracking Control of an Electro-Hydrostatic Actuator for a Disc Cutter Replacement Manipulator

Effects of Splined Shaft Bending Rigidity on Cylinder Tilt Behaviour for High-Speed Electro-Hydrostatic Actuator Pumps

Adaptive Backstepping Control of Electro Hydrostatic Actuator with Improved Parameter Estimation