Abstract:Biomass-derived fast pyrolysis liquid, also called bio-oil (FPBO), can replace petroleum fuels in thermal devices, but several undesirable properties hinder its widespread application. This paper aims to improve these properties and quantify their effect on its combustion performance. In this study, higher quality bio-oil having similar viscosity and surface tension as FPBO was obtained through the thermo-catalytic reforming bio-oil (TCRBO) process. The effect of fuel chemical composition, thermogravimetric analysis (TGA) residue, fuel volatility, heating value, water content, solid content, and ash content was examined in a 10 kW spray burner. Gas phase emissions and particulate matter (PM) were also measured and compared to its operation on fuel oil #2 for which diesel was used. TCRBO ignited irrespective of the primary air preheat temperature, and its evaporation characteristics (i.e., TGA residue of less than 3%) were more like diesel. TCRBO does not display any flash atomization. Both FPBO and TCRBO displayed coking potential; however, for TCRBO, no coking was observed if the primary air was heated above 110 °C. FPBO droplets were larger in size (∼100 μm) and could not achieve complete burnout due to increasing emissions. TCRBO exhibits lower emissions than FPBO at any given operating point, primarily due to better atomization achieved due to its higher fuel heating value, which reduced the fuel flow rate by almost 40%. FPBO resulted in the highest PM emissions, which can be attributed to the formation of secondary char particles. Higher fuel ash content also contributed to the PM emissions. The reduction in fuel water content (i.e., ∼2 wt %) made the TCRBO flame less susceptible to blow out, and a stable flame was observed without the pilot flame. Swirl and pilot were necessary to stabilize the FPBO flame. The TCRBO's higher fuel nitrogen content significantly increased its NOx emissions. Overall, thermo-catalytic reforming significantly improved the combustion characteristics of pyrolysis bio-oil. Although TCRBO was obtained from lower quality feedstock (e.g., sewage sludge), its superior combustion performance is attributed to the ability of the TCR process to produce higher quality liquid fuels from various biomass sources.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.energyfuels.1c04129.List of acronyms, schematic of the experimental setup, description of equipment, and main chemical constituents of FPBO/TCRBO (PDF)This article has not yet been cited by other publications.

Vacuum pyrolysis of Tamanu seed ( Calophyllum inophyllum ): Fuel properties, distillation, and composition study of the pyrolytic oil

Py-GC/MS and slow pyrolysis of tamarind seed husk

Improving the Quality of Fast Pyrolysis Bio-oil (Liquid Fuel) using Thermal Distillation Method

Analytical characterization of products obtained from slow pyrolysis of Calophyllum inophyllum seed cake: study on performance and emission characteristics of direct injection diesel engine fuelled with bio-oil blends

Thevetia peruviana Seed Oil Transesterification for Biodiesel Production: An Optimization Study

Co-pyrolysis behavior, engine performance characteristics, and thermodynamics of liquid fuels from mahua seeds and waste thermocol: A comprehensive study

Fractioned Preparation of Bio-Oil by Biomass Vacuum Pyrolysis

Fuel and Chemical Properties of Waste Tire Pyrolysis Oil Derived from a Continuous Twin-Auger Reactor

Bio-Oil Production from Multi-Waste Biomass Co-Pyrolysis Using Analytical Py–GC/MS

The Influence of Pyrolysis Time and Temperature on the Composition and Properties of Bio-Oil Prepared from Tanjong Leaves (Mimusops elengi)

Comparative analysis of N2 and H2 atmospheres in fast pyrolysis of mixed palm waste: Optimizing deoxygenation and hydrocarbon yield

Study on Biomass Pyrolysis and Emulsions from Biomass Pyrolysis Oils and Diesel

Optimal Bio-Oil Production Using Triplochiton scleroxylon Sawdust Through Microwave-Assisted Pyrolysis

Hydrocarbons Extracted from Advanced Pyrolysis Bio-Oils: Characterization and Refining

Thermal analysis and characterization study on Millingtonia hortensis towards bio-oil production by pyrolysis

Pyrolysis-Based Synthesis and Characterization of Bio-Oil From Brassica Carinata Oilseed Meals and Its Application to Produce Bio-Jet Fuel

Elucidating the pyrolysis reaction mechanism of Calotropis procera and analysis of pyrolysis products to evaluate its potential for bioenergy and chemicals

Catalytic Cracking of Inedible Oils for the Production of Drop-In Biofuels over a SO 4 2– /TiO 2 -ZrO 2 Catalyst

Kinetics of pyrolysis of de-oiled neem seeds (Azadirachta indica)

Bio-oil production from Moringa oleifera Lam. residue through fixed-bed pyrolysis

Advancing the Application of Pyrolysis Liquid (Bio-oil) by the Improvement of Its Fuel Properties by Thermo-Catalytic Reforming