Abstract:Determination of relation between oxides melts properties, based on silicates and calcium alum-silicates and magnesium and their chemical composition and structure is an important condition to provide a rational slag mode in a continuous casting machines mold. A mathematical simulation of slag melts and casting powders accomplished. The oxide-fluoride system was chosen for the simulation, for which the structure after solidification was determined by experiment. Results of molecular-dynamic simulation of CaO–SiO2–Al2O3–MgO–Na2O–K2O–CaF2–FeO system, correspondent to industrial casting powders composition, used during steel casting for slag formation in a CCM mold (35.35 % SiO2; 30.79 % CaO; 8.58 % Al2O3; 1.26 % MgO; 13.73 % CaF2; 7.57 % Na2O; 0.88 % K2O; 1.82 % FeO). Taking into account the concentration, a re-calculation was accomplished to mole shares and correspondent number of ions in the model for each component calculated. Simulation of the 8-component oxide-fluoride melt with 2003 ions size in the main cube (a side length of 31.01 Å) was accomplished at the experimentally determined temperature of solidification onset (1257 K) under periodic boundary conditions and fixed volume. The Coulomb interaction was taken into account by the Ewald–Hansen method. The time step was 0.05t0, where t0 = 7,608×10–14 sec is the internal unit of time. The melt density was taken as 3.04 g/cm3 based on the experimental data. The inter-particle interaction potentials were chosen in the Born–Mayer form. According to the simulation results, the structure of sub-crystalline groups of atoms present in the melt at the temperature of the onset of solidification was determined. A discussion of the simulation results and their comparison with the literature data presented.

Simulating the process of aluminum alloy ingots crystallization in semi-continuous casting

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Computerized simulation of shortened ingots with a controlled crystallization for manufacturing of high-quality forgings

The End-to-End Simulation of Semi-Continuous Casting and Subsequent Hot Rolling with Account of Microstructure

Numerical Simulation of Process of Electromagnetic Casting and Technology Features

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Simulation of the Technological Process of Manufacturing Continuous Metal Products on a Casting and Forging Module with a New Modification

Numerical Simulation of Temperature Field and Grain Structure in Cu-10Al Alloy Produced by Heated Mould Continuous Casting

Simulation of Mg-Gd Alloy During Solidification Process

Numerical Simulation of Semi-Solid Die-Casting Process of Automobile Aluminum Alloy Part

Simulation of Temperature Field and Microstructure in Heavy Steel Ingots Solidification

Mathematic simulation of atomic structure of multicomponent oxide-fluoride melt for continuous casting machines

Simulation of the Solidification Parameters of Single Crystal Casting

Physical simulation of nucleation and crystallization processes in transparent organic melts

Numerical Simulation of Macrosegregation Impurities in the Solidifying Continuous Casting Steel Billet

Simulation of microstructures in solidification of aluminum twin-roll casting based on CA

Numerical Simulation of Cast-rolling Process for Copper-Aluminum Composite Plate

Numerical modeling and simulation of water cooling-controlled solidification for aluminum alloy investment casting

Simulation of the as-cast structure of Al-4.0wt.%Cu ingots with a 5-phase mixed columnar-equiaxed solidification model

Simulation of the fluid flow in continuous casting copper slab mold for different SEN design

Numerical Simulation of Influence of Vertical Continuous Casting Process Parameters on Heat Transfer and Mold Stress of C71500 Large Diameter Hollow Ingot