Abstract:Similar material model test and numerical simulation method were used to study the reinforcement effect of isolation piles on the existing shield tunnel structure in the adjacent building construction for analyzing foundation pit excavation and new building construction approaching existing shield tunnel engineering. The numerical simulation orthogonal experiment was used to optimize four isolation pile parameters. The conclusions were obtained as follows: (1) Isolation piles could share horizontal load of the soil at the rear side of the support structure and reduce horizontal displacement of the soil. As a result, maximum horizontal displacement of the tunnel structure and differences in horizontal displacement between the tunnel structure roof and the floor after foundation pit excavation and building loading were decreased. The horizontal displacement and torsional deformation of the tunnel structure toward the direction of the foundation pit were controlled, and the increase in internal forces of the transverse tunnel structure was also restrained. (2) At the elevation above the tunnel roof, the increase in burial depth of the isolation pile top slightly affected the reinforcement effect on the tunnel structure. The increase in burial depth of the isolation pile bottom could improve the reinforcement effect. Thus, burial depth of the isolation pile bottom should be properly increased in the engineering practice. The reduction in pile spacing could improve the reinforcement effect. Accordingly, pile spacing should be properly selected in the engineering practice. With the increase of diameter of the isolation pile, the reinforcement effect of isolation piles increased obviously. (3) Pile diameter had the greatest influence on the reinforcement effect of isolation piles, followed by burial depth of the pile bottom, pile spacing, and burial depth of the pile top. Orthogonal experiments indicated the following optimal parameter values: a pile diameter of 1.2 m, a burial depth of the pile bottom of 2 H , a pile spacing of 1.6 m, and a burial depth of the pile top of 0.75 Z .

Analytical solutions for the restraint effect of isolation piles against tunneling-induced vertical ground displacements

Theoretical Analysis of Longitudinal Vertical Displacement of Subway Tunnels Caused by the Construction of Steel Casings for Bridge Piles

STUDY ON PILE LONGITUDINAL VIBRATION CONSIDERING EFFECT OF UNDERGROUND WATER LEVEL

Simplified Analysis Method for Evaluating Horizontal Deformation of Single Pile Due to Adjacent Foundation Pit Excavation

Analysis of the protective effect of setting isolation piles outside the foundation pit on the underpass tunnel side

Three-dimensional Isolation Analysis of a Row of Pile in Saturated Soil from Incident S Waves

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

1 g Model Test on the Use of Isolation Piles for Tunnel Protection Adjacent to Soft Soil Excavation

Analysis of influence of position of arch double row isolated pile on existing tunnel

Reinforcement Effects of Isolation Piles on the Adjacent Existing Tunnel in Building Construction

Elastic Solutions for Partially Embedded Single Piles Subjected to Simultaneous Axial and Lateral Loading

Vertical Amplitude Reduction of Rayleigh Waves by a Row of Piles in a Poroelastic Half‐space

Complex Variable Solutions for Tunneling-Induced Ground Movement

Analytical Solution of Deformation of Underlying Shield Tunnel Caused by Foundation Pit Excavation and Dewatering

Vertical mechanical response of axial loaded pile to tunneling-induced pile exposure

Elastoplastic Solutions for Single Piles under Combined Vertical and Lateral Loads

3D Analytical Solution of Soil Deformation Induced by Shield Tunnelling Construction

Longitudinal Dynamic Response of Pile Foundation in a Nonuniform Initial Strain Field

Analytical solution of seismic response for tunnel covered by an isolation layer under longitudinally propagating shear waves

Three-dimensional displacement characteristics of adjacent pile induced by shield tunneling under influence of multiple factors

Analytical solution for the dynamic response of a pile with a variable-section interface in low-strain integrity testing