Study on liquid dielectrophoresis based on double flexible electrodes simulating interdigitated pattern electrodes

Shang Xiu-Ting,Chen Tao,Chen Jing,Xu Rong-Qing,

DOI: https://doi.org/10.7498/aps.73.20231485

IF: 0.906

2024-01-01

Acta Physica Sinica

Abstract:Dielectrophoresis works on the dipoles through entire dielectric liquid through a non-uniform electric field, reversibly changing the droplet contact angle, and overcoming the contact angle saturation limit of electrowetting to affect the surface wettability as a volume force. However, it is difficult to realize useful three-dimensional tunable optical devices because most of the driving electrodes need to be patterned. This paper proposes a model of double flexible electrodes simulating planar interdigitated pattern electrodes based on the dielectrophoresis. Double flexible electrodes wrapped with an insulation layer and disconnected, arranged at close intervals, and wound along the plane substrate to form a two-dimensional plane line wall. A hydrophobic layer is applied to fill the gap and increase the initial contact angle. Ultimately, the "dropletinterdigitated planar line wall" dielectrophoresis driven-droplet model is formed after the dielectric droplets are deposited on the line wall's surface. Firstly, considering the influence of penetration depth and electrode gap area, Young's equation is theoretically modified to adapt to this model. Then, the potential distribution of this model and the planar interdigitated pattern electrode model is compared and analyzed by finite element algorithm simulation. The field strength distribution of the electrode with different wire diameters and insulating layer thicknesses is analyzed. It can be found that with the increase of the diameter of the electrode wire and the thickness of the insulating layer, the morphology of the model changes from the tip electrode to the planar electrode, the surface field strength attenuates exponentially and the peak value decreases. This shows that the electrode structure in this model is superior to the planar electrode. After that, the contact angle of the model is measured experimentally in the range of[58°, 90°] under a 0-250 Vrms voltage, which is in line with the theoretical expectation. At the same time, no obvious contact angle lag or saturation were observed in the experiment. Finally, the new electrophoretic driving droplet model constructed in this paper transforms the dielectric electrophoretic driving mode from a twodimensional planar electrode to a one-dimensional flexible linear electrode. Because of its flexibility and plasticity, it is convenient to form a three-dimensional cavity and can be applied to more complex device structures.

physics, multidisciplinary