Fabrication and Optimal Design of a Mechanical Piezoelectric Energy Harvester with Re-entrant Honeycomb Substrate for Maximizing Voltage Output

Mohamad Hossein Fatahi,Mohsen Hamedi,Majid Safarabadi

DOI: https://doi.org/10.1007/s12541-023-00922-4

IF: 2.0411

2023-11-02

International Journal of Precision Engineering and Manufacturing

Abstract:The low specific power of mechanical energy harvesters is the biggest shortcoming prevents these harvesters from becoming a viable replacement for batteries used in monitoring structures. In this paper, increasing the output voltage of the mechanically excited piezoelectric harvester beams was investigated. A composite beam consisting of an auxetic honeycomb, skin, piezo layer and end mass was optimally designed and subjected to base excitation. Two samples with homogenous and honeycomb substrates were fabricated and tested. The measured natural frequencies showed good agreement with the FE model results with 7% average error. The equivalent properties of the honeycomb were extracted and verified and formed a homogenous orthotropic layer. Geometry of honeycomb and beam was considered for the optimization process. The length of the beam, as an input parameter, was used in an inner loop inside the optimization cycle to set the natural frequency near 50 Hz. Measuring the performance of the two beams with the same size of the piezoelectric layer showed that auxetic honeycomb substrate improves the open-circuit voltage above 25% and the specific voltage above 30% compared with the simple substrate.

engineering, mechanical, manufacturing