Abstract:The rotating parts looseness is one of the common failures in rotating machinery. The current researches of looseness fault mainly focus on non-rotating components. However, the looseness fault of disc-shaft system, which is the main work part in the rotor system, is almost ignored. Here, a dynamic model of the rotor system with loose disc caused by the insufficient interference force is proposed based on the contact model of disc-shaft system with the microscopic surface topography, the vibration characteristics of the system are analyzed and discussed by the number simulation, and verified by the experiment. The results show that the speed of the shaft, the contact stiffness, the clearance between the disc and shaft, the damping of the disc and the rotational damping have an influence on the rotation state of the disc. When the rotation speed of the disc and the shaft are same, the collision frequency is mainly composed of one frequency multiplication component and very weak high frequency multiplication components. When the rotation speed of the disc and the shaft is close, the vibration of the disc occurs a beat vibration phenomenon in the horizontal direction. Simultaneously, a periodical similar beat vibration phenomenon also occurs in the waveform of the disc-shaft displacement difference. The collision frequency is mainly composed of a low frequency and a weak high frequency component. When the rotation speed of the disc and the shaft has great difference, the collision frequency is mainly composed of one frequency multiplication, a few weak high frequency multiplication components and a few low frequency multiplication component. With the reduction of the relative speed of the disc, the trajectory of the disc changes from circle-shape to inner eight-shape, and then to circle-shape. In the inner eight-shape, the inner ring first gradually becomes smaller and then gradually becomes larger, and the outer ring is still getting smaller. The obtained research results in this paper has important theoretical value for the diagnosis of the rotor system with the loose disc.

Dynamic characteristics of a rod-fastening rotor system with tie rod bolt loosening

Dynamics of a Rod-Fastened Rotor Considering the Bolt Loosening Effect

Bolt loosening at rotating joint interface and its influence on rotor dynamics

Numerical and experimental investigations on dynamic behaviors of a bolted joint rotor system with pedestal looseness

Thin-layer element method for multi-stage rotor bolt loosening identification

Dynamics modeling and experimental modal analysis of bolt loosening for lightning rod

Speed Characteristics of Disk–shaft System with Rotating Part Looseness

Coupling dynamics of pedestal looseness and impact-rub for rotor system with nonlinear support

Measured and investigated nonlinear dynamics parameters on bolted flange joints of combined rotor

Numerical Studies on Time-Varying Stiffness of Disk-Drum Type Rotor with Bolt Loosening

Modeling of Preload Bolted Flange Connection Structure for Loosening Analysis and Detection

Modeling and dynamic analysis for rotors with curvic-coupling looseness

Dynamic Model and Fault Feature Research of Dual-Rotor System with Bearing Pedestal Looseness

Nonlinear Dynamic Analysis for a Jeffcott Rotor Considering Varying Connection Stiffness of Bolted Joint

Nonlinear dynamic of the rod-fastening combined rotor system with rub-impact based on the Stribeck friction model

Dynamic characteristic analysis of a twin-spool rotor–casing system with looseness and intershaft rubbing coupling faults

Vibration Characteristics of Rotor System with Loose Disc Caused by the Insufficient Interference Force

Study on the influence of joint parameters on nonlinear dynamics of a rotor system

Critical load determination for preventing rotational loosening in bolted joints under dynamic transverse loads

Dynamic Modeling of Tie-bolt Rotors via Fractal Contact Theory and Virtual Material Method

Nonlinear vibration characteristics of rotor-bearing system with disc-shaft insufficient interference and flexible coupling misalignment fault