Catalytic hydrolysis of corncob for production of furfural and cellulose-rich solids: Product characterization and analysis
Bang Yao,Qinhao Kang,Jie Fu,Yang Liu,Wenya Ao,Long Wang,Zhihui Jiang,Tianhao Zhang,Yongmeng Song,Zeyu Deng,Asif Ali Siyal,Jianjun Dai
DOI: https://doi.org/10.1016/j.biombioe.2022.106658
IF: 5.774
2022-11-27
Biomass and Bioenergy
Abstract:Experiments were carried out to investigate cellulose and furfural from catalytic hydrolysis of corncob. This process improved the comprehensive utilization of hemicellulose and cellulose in biomass resources. Influence of factors (temperature, reaction time, concentration of catalysts, liquid to solid ratio (LSR)) on hydrothermal characteristics, furfural yield, properties and retention of cellulose were investigated through orthogonal and parameter tests. Acetic acid (6 wt%) and FeCl 3 (40 mM) achieved the highest furfural yield (47.60%) and relatively high cellulose retention ratio (71.84%) at 180 °C, 45 min, and 3 mL/g of LSR. While AlCl 3 and citric acid obtained low furfural yield and the lowest cellulose retention ratio (8.38%). Furfural was dominant in distillated organics (GC-MS areas ≥97.9%), by contrast furfural, 5-hydroxymethyfurfural and vanillin were main organics in residual liquors. The peak of furfural yield switched to shorter reaction time as temperature increased. Combination of AlCl 3 with acetic acid and citric acid accelerated cellulose degradation. NaCl inhibited furfural yield and promoted lignin decomposition. Higher temperature and greater concentration of FeCl 3 contributed to reduced crystallinity of cellulose during hydrothermal treatment.
energy & fuels,biotechnology & applied microbiology,agricultural engineering