Abstract:Packed in: The doped DPP (diketopyrrolopyrole)‐EDOT(3,4‐ethlenedioxythiophene) polymer shows high thermoelectric performance with PF = 571 ± 38 μW m−1 K−2 and ZT = 0.28 ± 0.02, after incorporation of an ionic additive, which can boost the Seebeck coefficient through increasing the energetic disorder and decreasing the p‐type doping degree. The thermoelectric (TE) performance of organic materials is limited by the coupling of Seebeck coefficient and electrical conductivity. Herein a new strategy is reported to boost the Seebeck coefficient of conjugated polymer without significantly reducing the electrical conductivity by incorporation of an ionic additive DPPNMe3Br. The doped polymer PDPP‐EDOT thin film exhibits high electrical conductivity up to 1377 ± 109 S cm−1 but low Seebeck coefficient below 30 μV K−1 and a maximum power factor of 59 ± 10 μW m−1 K−2. Interestingly, incorporation of small amount (at a molar ratio of 1:30) of DPPNMe3Br into PDPP‐EDOT results in the significant enhancement of Seebeck coefficient along with the slight decrease of electrical conductivity after doping. Consequently, the power factor (PF) is boosted to 571 ± 38 μW m−1 K−2 and ZT reaches 0.28 ± 0.02 at 130 °C, which is among the highest for the reported organic TE materials. Based on the theoretical calculation, it is assumed that the enhancement of TE performance for the doped PDPP‐EDOT by DPPNMe3Br is mainly attributed to the increase of energetic disorder for PDPP‐EDOT.

Enhanced thermoelectric performance of pentacene via surface charge transfer doping in a sandwich structure

Tailoring P-N Conversion in All-solid-state Polymer Composites with A Record Ionic Thermopower

Introduction of F-4-Tcnq/Moo3 Layers for Thermoelectric Devices Based on Pentacene

Doping optimization of organic-inorganic hybrid perovskite CH3NH3PbI3 for high thermoelectric efficiency

Unravelling Doping Effects on Pedot at the Molecular Level: from Geometry to Thermoelectric Transport Properties

Polaron Interfacial Entropy As a Route to High Thermoelectric Performance in DAE-doped PEDOT:PSS Films.

Doping optimization of organic-inorganic hybrid perovskite CH 3 NH 3 PbI 3 for high thermoelectric ef fi ciency

Enhanced Molecular Packing of a Conjugated Polymer with High Organic Thermoelectric Power Factor.

Utilizing perylene diimmide as dopant to improve thermoelectric performance of PEDOT:PSS films

Achieving Efficient p‐Type Organic Thermoelectrics by Modulation of Acceptor Unit in Photovoltaic π ‐Conjugated Copolymers

Thermopower enhancement in conducting polymer nanocomposites via carrier energy scattering at the organic-inorganic semiconductor interface

Boosting the Thermoelectric Performance of the Doped DPP‐EDOT Conjugated Polymer by Incorporating an Ionic Additive

Low‐Symmetry PdSe 2 for High Performance Thermoelectric Applications

Observation of Hole Injection Boost Via Two Parallel Paths in Pentacene Thin-Film Transistors by Employing Pentacene: 4, 4″-Tris(3-methylphenylphenylamino) Triphenylamine: MoO3 Buffer Layer

Low‐Symmetry PdSe2 for High Performance Thermoelectric Applications

Oxidation Control to Augment Interfacial Charge Transport in Te-P3HT Hybrid Materials for High Thermoelectric Performance

Study of thermoelectric properties in the PEDOT:PSS/Te double-layer thin film devices

"Doping" pentacene with sp(2)-phosphorus atoms: towards high performance ambipolar semiconductors

First-Principles Investigation of Organic Semiconductors for Thermoelectric Applications

A cyano-rich small molecule dopant for organic thermoelectrics

Improved Performance Of P-Type Pentacene Thin Film Transistor By Inserting Thin Interlayer Of N-Type Organic Semiconductor