Abstract:The seismic performance of buildings can be improved by adding supplemental damping using friction dampers. The friction behavior of the metallic shims becomes more stable with increasing surface hardness ratio between the friction pair. However, as hardness increases, metallic materials tend to become more brittle, which increases the risk of accidental failure. This study investigated the performance of a friction energy dissipator using bearing steel (GCr15) treated by a grinding-strengthening process, a special manufacturing technology for bearings steel commonly used in mechanical engineering. Two base materials, Q355 and B450, were additionally compared with GCr15. Each base material used three different surface treatments, i.e., cleaned surface (CS), sand-blasting (SB), and grinding-strengthen (GS) treatments. The surface hardness of Q355-GS, B455-GS, and GCr15-GS increased by 13.62 %, 17.38 %, and 19.71% compared to their base materials, while sand-blasting didn't have an increased effect on surface hardness. The nine specimens were quasi-statically tested to investigate the effect of surface treatment on the friction behavior of the metallic shims. For the three Q355-like and three B450-like specimens, the wear mechanism mixed abrasive and adhesive wear. The GCr15-CS experienced contact fatigue failure, while the GCr15-SB and GCr15-GS exhibited abrasive wear resulting in standard rectangular hysteretic loops with a high degree of coincidence. The friction performance of GCr15-GS was the best among the nine friction shims, because it has less loss in friction coefficient and strength during fatigue loading, the least fluctuation in bolt force, and the smallest degradation and coefficient of variation in friction strength.

Experimental testing of GCr15 bearing steel with different surface treatments as passive friction energy-dissipative shims

Effects of Surface Texturing and Laminar Plasma Jet Surface Hardening on the Tribological Behaviors of GCr15 Bearing Steel

Study on fretting friction properties based on GCr15 alloy and liquid epoxy resin protective coatings on GCr15 alloy

Experimental Studies on Slip Friction Device Using Symmetric Friction Connections

Sliding Friction and Wear Properties of GCr15 Steel under Different Lubrication Conditions

Experimental study on seismic performance of laminated rubber bearings with friction slipping

Experimental Study on Frictional Behavior of Different Structural Materials

Investigation on Microstructure and Fretting Wear Properties of GCr15 Bearing Steel Modified by Fine Particle Bombardment

Effect and performance analysis of different surface treatments on polymer-metal friction pairs

Comparing Friction Behavior and Mechanism of Three Generation Bearing Steel (gcr15, M50, CSS-42L) Paired Silicon Nitride under Ester Oil Lubrication from Room Temperature to 350 °C

Friction and wear behavior of Fe2AlB2 nanolaminates against GCr15 steel counterpart

Enhancing tribological performance of graphene sheet-embedded carbon films on steel substrates via texture engineering and chromium doping

The Analyses of 9cr18 and GCr15 Ball-disc Friction Couple's Tribological Property

Comparison of wear behavior of GCr15 bearing steel prepared by selective laser melting (SLM) and electron beam melting (EBM)

Friction and wear characteristics of plasma-sprayed WC coatings in dliding against GCr15 steel

Performance Evaluation of Friction Dampers Considering Different Metal Pairs and Loading Rates

Surface Microstructure Refinement and Mechanical Properties of GCr15 Steels Improved During Ultrasonic Surface Rolling Processing

Study on Fretting Wear Properties of GCr15 Steel Via Ultrasonic Surface Rolling Process

Insights into the microstructure characteristics, mechanical properties and tribological behaviour of gas-phase chromized coating on GCr15 bearing steel

Influence of the Machining Process on the Wear Properties of Self-Mated Structural Steel in Dry Sliding Conditions

Tribological behavior of heat treated AISI 6150 steel