Extraction of collagenolytic proteases from Aspergillus heteromorphus URM 0269 in an aqueous two-phase system for application in collagen hydrolysis

Beatriz de Aquino Marques da Costa,Ana Cláudia Vaz de Araújo,Lígia Maria Gonçalves Fernandes,Ana Lúcia Figueiredo Porto,Vagne de Melo Oliveira,Tatiana Souza Porto
DOI: https://doi.org/10.1080/10826068.2023.2263870
2023-10-11
Preparative Biochemistry & Biotechnology
Abstract:Collagenolytic proteases produced by Aspergillus heteromorphus URM0269 were extracted using a PEG/sulfate aqueous two-phase system (ATPS). A 2 3 factorial design was performed to analyze the independent variables: PEG molar mass (M PEG ), PEG concentration (C PEG ), and sulfate concentration (C sulf ). The extracted proteases were also evaluated for their optimum pH and stability at different pH levels (4.0 − 11.0) after 20 h of incubation. Collagen was extracted from mutton snapper ( Lutjanus analis) skin using acetic acid (0.5 mol L −1 ). The enzyme was preferentially partitioned to the PEG-rich phase (K > 1), whose highest purification factor and recovery (PF = 6.256 and Y = 404.432%) were obtained under specific conditions: M PEG 8000 g.mol −1 , C PEG 30%, C sulf 10%. The ATPS extraction provided an enzymatic activity range of pH 7.0 − 11.0, exhibiting greater stability compared to the crude extract. Approximately 80% of protease activity was maintained after 20 hours of incubation at all analyzed pH levels, except pH 11.0. Collagen extraction from L. analis skin yielded 8.056%, and both crude extract samples and ATPS-derived samples successfully hydrolyzed the extracted collagen, reaching peak hydrolysis after 36 hours of treatment. These findings demonstrate the feasibility of extracting highly purified and active proteases capable of hydrolyzing L. analis collagen.
biotechnology & applied microbiology,biochemical research methods,biochemistry & molecular biology
What problem does this paper attempt to address?