Abstract:The roughness coefficient is an important influencing factor of the joint shear strength. However, the research of size effect on joint roughness coefficient has not gained great progress due to surface morphology complexity of rock joint. This paper summarizes three methods to obtain joint roughness coefficient, i. e. standard profile comparison method, theoretical equation method and inverse analysis method, and then analyzes some existing problems and difficulties on studying size effect on joint roughness coefficient. In order to achieve the relationship between joint roughness coefficient and sample size, the ratios of raw materials such as medium sand, silica fume, cement, non-air entraining naphthalene super-plasticizer, are firstly investigated. Then rock materials for simulation are obtained, in which physico-mechanical properties are similar to calcareous slate. Finally, eight groups of rock joints with 176 pairs of different sizes and roughness are made through molds in preparation process. In addition, the roughness coefficients of rock joints are tested by homemade push-pull shear apparatus and experimental data are further analyzed. The results show that statistical mean values of joint roughness coefficient generally decrease with the increase of sample size. However, the size effect tests on the specific rock joints need to be performed through push-pull shear strength testing method. It is found that size effect variations calculated by Barton formula are in good agreement with experimental results, whereas the theoretical and experimental values are different. In particular, when the size of sample is smaller, the differences are greater. Furthermore, rock roughness coefficients even with specific joint surfaces are various and the roughness coefficients of large size rock joint should be comprehensively judged according to the surface morphology and distribution.

The Influence of Different Shear Directions on the Shear Resistance Characteristics of Rock Joints

A New Method for Determination of Joint Roughness Coefficient of Rock Joints

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

On Size Effect of Rock Joints Roughness Based on Varied Statistical Methods

Neutrosophic Functions of the Joint Roughness Coefficient and the Shear Strength: A Case Study from the Pyroclastic Rock Mass in Shaoxing City, China

Correlation Between the Joint Roughness Coefficient and Rock Joint Statistical Parameters at Different Sampling Intervals

An experimental study of size effect of roughness coefficient on rock joint using push-pull apparatus

Revisiting Scale Effect on Joint Roughness Coefficient and Shear Strength Considering Sampling Methods and Geometric Characteristics

A New 3D JRC Calculation Method of Rock Joint Based on Laboratory-Scale Morphology Testing and Its Application in Shear Strength Analysis

Characterization of Rock Joint Roughness from the Classified and Weighted Uphill Projection Parameters

The Impact of Shear Rate on the Mechanical Behavior of Rock Joints Under Multiple-Influencing Factors

Experimental and Numerical Study on the Shear Behaviour of Standard JRC Double-Joint Rock Masses

Numerical Investigations of the Dynamic Shear Behavior of Rough Rock Joints

An Experimental and Analytical Study of Rate-Dependent Shear Behaviour of Rough Joints

Effect of Roughness on the Shear Behavior of Rock Joints Subjected to Impact Loading

Rate-dependent mechanical behavior of rough rock joints

Numerical Simulation on the Effect of Rock Joint Roughness on the Stress Field

2D and 3D Evaluation of Joint Roughness Exposed by Rock Cores

New 2D roughness parameters with geometric and physical meanings for rock joints and their correlation with joint roughness coefficient

Study on the Effect of Rock Strength on the Macro-Meso Shear Behaviors of Artificial Rock Joints

Numerical Simulation Study on Shear Properties of Rock Joint Under CNS Boundary Conditions