Abstract:The roughness coefficient is an important influencing factor of the joint shear strength. However, the research of size effect on joint roughness coefficient has not gained great progress due to surface morphology complexity of rock joint. This paper summarizes three methods to obtain joint roughness coefficient, i. e. standard profile comparison method, theoretical equation method and inverse analysis method, and then analyzes some existing problems and difficulties on studying size effect on joint roughness coefficient. In order to achieve the relationship between joint roughness coefficient and sample size, the ratios of raw materials such as medium sand, silica fume, cement, non-air entraining naphthalene super-plasticizer, are firstly investigated. Then rock materials for simulation are obtained, in which physico-mechanical properties are similar to calcareous slate. Finally, eight groups of rock joints with 176 pairs of different sizes and roughness are made through molds in preparation process. In addition, the roughness coefficients of rock joints are tested by homemade push-pull shear apparatus and experimental data are further analyzed. The results show that statistical mean values of joint roughness coefficient generally decrease with the increase of sample size. However, the size effect tests on the specific rock joints need to be performed through push-pull shear strength testing method. It is found that size effect variations calculated by Barton formula are in good agreement with experimental results, whereas the theoretical and experimental values are different. In particular, when the size of sample is smaller, the differences are greater. Furthermore, rock roughness coefficients even with specific joint surfaces are various and the roughness coefficients of large size rock joint should be comprehensively judged according to the surface morphology and distribution.

A New 3D JRC Calculation Method of Rock Joint Based on Laboratory-Scale Morphology Testing and Its Application in Shear Strength Analysis

A New Method for Determination of Joint Roughness Coefficient of Rock Joints

Correlation Between the Joint Roughness Coefficient and Rock Joint Statistical Parameters at Different Sampling Intervals

A Rapid Field Measurement Method for the Determination of Joint Roughness Coefficient of Large Rock Joint Surfaces

Estimation of the joint roughness coefficient (JRC) of rock joints by vector similarity measures

On Size Effect of Rock Joints Roughness Based on Varied Statistical Methods

Experimental Technology for the Shear Strength of the Series-Scale Rock Joint Model

An experimental study of size effect of roughness coefficient on rock joint using push-pull apparatus

Neutrosophic Functions of the Joint Roughness Coefficient and the Shear Strength: A Case Study from the Pyroclastic Rock Mass in Shaoxing City, China

Method for Visualizing the Shear Process of Rock Joints Using 3D Laser Scanning and 3D Printing Techniques

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

3D Morphology Reconstruction of Rock Joints from 2D Profile Measurement by a Profilograph

New 2D roughness parameters with geometric and physical meanings for rock joints and their correlation with joint roughness coefficient

Characterization of Rock Joint Roughness from the Classified and Weighted Uphill Projection Parameters

2D and 3D Evaluation of Joint Roughness Exposed by Rock Cores

Revisiting Scale Effect on Joint Roughness Coefficient and Shear Strength Considering Sampling Methods and Geometric Characteristics

Estimation of the Lengths of Intact Rock Core Pieces and the Corresponding RQD Considering the Influence of Joint Roughness

Study on Mechanical Model for Postpeak Shear Behavior of Rock Joints Based on Degradation Characteristics of the 3D Morphology

Numerical Simulation on the Effect of Rock Joint Roughness on the Stress Field

A new method for determining mechanical parameters of joints based on triaxial compressive test for rock mass

Measurement of Joint Roughness Coefficient by Using Profilograph and Roughness Ruler