Enhancing Supercapacitor Performance of NiCoMn‐Layered Double Hydroxide with Ag–Citrate/Polyaniline Nanocomposites

Ammar Makda,Mohsin Ali Marwat,Muhammad Hamza Mahmood,Abdullah Naeem,Syed Muhammad Abdullah,Muhammad Humayun,Muhammad Ramzan Abdul Karim,Mohamed Bououdina,Muhammad Zubair Khan,Muhammad Bilal Hanif
DOI: https://doi.org/10.1002/ente.202401730
IF: 4.149
2024-11-27
Energy Technology
Abstract:The NiCoMn‐layered double hydroxide (LDH)/Ag/polyaniline (PANI) nanocomposite enhances supercapacitor performance by combining Ag–citrate, which improves conductivity and pseudocapacitance, with PANI, which boosts electrical conductivity and electric double‐layer capacitor behavior. Situated between NiCoMn LDH layers, Ag–citrate and PANI work together to enable efficient energy storage through a blend of pseudocapacitive and electrochemical double‐layer mechanisms. Layered double hydroxide (LDH) has a layered structure, which makes it a strong candidate for supercapacitors (SC) due to its high surface area. However, they suffer from low conductivity due to insufficient charge transfer across their layers. This research aims to overcome this obstacle by introducing conductive channels among the layers by the addition of Ag–citrate and polyaniline (PANI). Consequently, five electrodes (S1–5) were made from NiCoMn LDH (referred to as LDH henceforth) and 2:1 Ag–citrate and PANI composite (Ag/PANI) in different ratios and made into electrodes. Electrochemical analysis revealed successful improvement in the performance of LDH as the fraction of Ag/PANI increased until it equaled Ag/PANI where the highest specific capacitance of 617 F g−1 was obtained, which is 12% greater than the value for solely LDH electrode (550 F g−1). A device was fabricated with the best electrode (S3) and activated carbon electrode, which demonstrated energy densities and power densities of 41 WhKg−1 and 412.5 W Kg−1 and 14 WhKg−1and 8250 W Kg−1 at 0.5 and 10 A g−1 current densities, respectively. It also exhibited a capacitive retention of about 75% at 3000 galvanostatic charge–discharge cycles. These results encourage the use in of NiCoMn LDH, in a 1:1 ratio with Ag/PANI in SCs due to its remarkable performance.
energy & fuels
What problem does this paper attempt to address?