Fractional model for simulating Long-Term fracture conductivity decay of shale gas and its influences on the well production

Yu Peng,Ang Luo,Yongming Li,Yijia Wu,Wenjun Xu,Kamy Sepehrnoori

DOI: https://doi.org/10.1016/j.fuel.2023.129052

IF: 7.4

2023-06-20

Fuel

Abstract:Due to the high-content of clay and kerogen, shale will always show viscoelastic mechanical behaviors during the development of shale gas, which will lead to the increase of proppant embedment and do harm to gas recovery from shale reservoirs. In the previous studies, viscoelastic mechanical behaviors of reservoir rock had not been coupled with productivity model of gas well and the long-term fracture conductivity was overestimated. In order to figure out the creep damage to long-term fracture conductivity and predict the estimated ultimate recovery of shale gas wells accurately, a novel time-varying fracture conductivity model based on fractional calculus was developed for simulating the long-term decay of fracture conductivity. Proppant deformation, proppant embedment, and shale creep described by fractional Kelvin model were taken into consideration in the time-varying fracture conductivity model and it was coupled with embedded discrete fracture model (EDFM) to simulate the well performance. Simulation results show that: Daily gas production curve simulated by the EDFM with creep damage under field conditions of a shale gas well in Sichuan Province, China was aligned with its production data. The damage rate of cumulative production considering shale creep is more than twice that only caused by proppant deformation and proppant embedment. And the formation viscous modulus determines the strength of the shale viscoelastic mechanical behaviors. According to formation viscous modulus, the shale reservoirs can be divided into three types: Type I with strong creep damage ( E 2 v < 5GPa), Type II with moderate creep damage (5GPa < E 2 v < 30GPa), and Type III with few creep damage ( E 2 v > 30GPa).

energy & fuels,engineering, chemical