Abstract:In this paper, a new group of active impedance source inverters, along with a suitable control method based on the pulse width modulation (PWM) technique, is presented. Using the proposed control method to produce the gate pulse of the switches, all operating modes of one of the proposed inverters, in two different operations (synchrony and asynchrony), to calculate boost factor and critical inductance in the boundary condition, are analyzed. The comparative analysis from different points of view, such as boost factor, total voltage blocked by diodes and switches, and voltage stresses on capacitors between the proposed topology and conventional structures to examine the advantages and disadvantages, is done. Summary In this paper, a new group of active impedance source inverters, along with a suitable control method based on the pulse width modulation (PWM) technique, is presented. The purpose of these inverters is to reduce the voltage stress on capacitors, diodes, and switches compared to other topologies. Using the proposed control method to produce the gate pulse of the switches, all operating modes of one of the proposed inverters, in two different operations (synchrony and asynchrony), to calculate boost factor and critical inductance in the boundary condition, are analyzed. Furthermore, all equations of voltage and current of components to design the suitable amounts of capacitors and inductors are calculated. Then, the comparative analysis from different points of view, such as boost factor, total voltage blocked by diodes and switches, and voltage stresses on capacitors between the proposed topology and conventional structures to examine the advantages and disadvantages, is done. Also, the losses and efficiency of the proposed topology at different loads are fully given. Finally, a prototype of the proposed topology is designed, and its experimental results are provided to check the performance and correctness of the obtained equations in different operating modes.

A single phase modified Y-source inverter with high voltage gains and reduced switch stresses

A High Step-up Multilevel Inverter with Minimized Components Featuring Self-balancing and Continuous Input Current Capabilities

Reduced Switch‐count Structure for Symmetric Multilevel Inverters with a Novel Switched‐dc‐source Submodule

An Embedded Enhanced-Boost Z-Source Inverter

Single-Source Cascaded Multilevel Inverter With Voltage-Boost Submodule and Continuous Input Current for Photovoltaic Applications

A Novel Symmetrical Boost Modulation Method for qZS-based CHB Inverters

Modified Modulation Techniques for Quasi-Z-Source Cascaded H-Bridge Inverters

A Switched Quasi-Z-Source Inverter with Continuous Input Currents

Improved ultra voltage gain switched inductor based-Y-Source DC/DC converter with low device stress

A Modified Y-Source DC–DC Converter with High Voltage-Gains and Low Switch Stresses

Three-Phase Split-Source Inverter (SSI)

Modeling And Control Of Single-Phase Quasi-Z-Source Inverters

A Generalized Three-Phase Multilevel Current Source Inverter with Carrier Phase-Shifted SPWM

New multilevel inverter based on reduced switch basic cell for high voltage levels

A new class of active impedance source inverter with low voltage stress on semiconductors

Z-Source\/Quasi-Z-Source Inverters: Derived Networks, Modulations, Controls, and Emerging Applications to Photovoltaic Conversion

A Comparison Analysis of a New Switched-Inductor and Conventional Split Source Inverter Structures

Modeling and stability analysis of enhanced gain active switched inductor impedance source non-isolated DC to DC converter for PV applications

The Hardware Implementation of Three- Phase Split-Source Inverter (SSI)

Generalized Switched-Capacitor-Based Hybrid Multilevel Inverter With Reduced Components Count and Inrush Current

A Novel Single-Phase Five-Level Current-Source Inverter Topology