Abstract:This paper presents the closed-loop control of a single-switch high-gain multicell boost DC-DC converter working in a continuous conduction mode (CCM). This converter is particularly designed for applications in photovoltaic systems. One of the main advantages of the proposed converter is that it only employs one active semiconductor switch, which decreases the converter losses and cost, increases the efficiency, and simplifies the control circuit. Moreover, the multicell nature of the proposed converter offers the possibility of obtaining the required voltage gain by selecting the number of cells. State space average (SSA) modeling and small-signal analysis are used to model the switching converter power stages of the proposed converter. The parasitic series resistances of the passive elements of the converter circuit are considered to improve the accuracy of the modeling. Small-signal analysis is used to derive the open-loop transfer functions, input-to-output and control-to-output transfer functions of the proposed converter to examine its dynamic performance. The stability of the converter is analyzed to design the parameters of the voltage controller using the proposed modeling method. The experimental prototype of the proposed single-switch two-cell boost DC-DC converter was implemented. The simulation and experimental results proved the effectiveness of the proposed boost DC-DC converter under different working conditions. It has a fast dynamic response without overshoots. A comprehensive comparison between the proposed converter and previous boost converters is provided. It guarantees a required variable and constant high voltage gain with a wider duty ratio range. It compromises between the required performance, the low number of components, low voltage stress on the components, and cost-effectiveness. The experimental efficiency of the proposed converter is about 96% at a 100 W load.

Modeling and stability analysis of enhanced gain active switched inductor impedance source non-isolated DC to DC converter for PV applications

Small-Signal Modeling And Experimental Validation Of The Three-Phase Quasi-Z-Source Inverter

Analysis and Design of Zero-Voltage-Switching Multiphase AC/DC Converters

High-Gain Symmetrical Z-Source Hybrid Converter with Low Leakage Currents

State-Space Modeling, Design, and Analysis of the dc-dc Converters for PV Application: A Review

A Switched Quasi-Z-Source Inverter with Continuous Input Currents

High gain multi-input single-output DC-DC boost converter with enhanced circuit for photovoltaic applications

Modeling And Control Of Single-Phase Quasi-Z-Source Inverters

High‐Gain Z‐Source DC‐DC Converter With Low Voltage Stress for Photovoltaic Power Systems

Small-Signal Modeling and Dynamic Analysis of the Quasi-Z-Source Converter.

State Space Average Modeling, Small Signal Analysis, and Control Implementation of an Efficient Single-Switch High-Gain Multicell Boost DC-DC Converter with Low Voltage Stress

Design and Analysis of Novel High-Gain Boost Converter for Renewable Energy Systems (RES)

Design and Experimental Investigation of Zeta Converter Fed Reduced Switch Multi-stage Grid Connected Boost MLI

A new wide input voltage DC-DC converter for solar PV systems with hybrid MPPT controller

Performance Evaluation of Solar-PV-Based Non-Isolated Switched-Inductor and Switched-Capacitor High-Step-Up Cuk Converter

A Dual-Active-Clamp Quasi-Resonant Isolated Boost Converter for PV Integration to Medium-Voltage DC Grids

Design and Implement of an Active-clamp Isolated Boost Converter for PV Systems

Design of a high voltage gain converter using coupled inductor with reduced voltage stress for photovoltaic energy based systems

A non-isolated converter of switching current stress in DC-DC converter for integrating PV and battery storage system

A high gain quasi Z‐source based full‐bridge isolated DC‐DC converter with extendable structure for grid‐tied/standalone PV system

Analysis and Development of SiC MOSFET Boost Converter as Solar PV Pre-regulator