Abstract:Development of non-platinum electrocatalysts for oxygen reduction reaction (ORR) is required for wide commercialization of polymer electrolyte fuel cells. We focused on titanium oxide-based electrocatalysts, because of their high chemical stability and much less expensive than platinum. We found that Ti-Nb complex oxide mixed with magneli phase titanium oxide (Ti 4 O 7 ) had high ORR onset potential and superior durability [1]. However, the ORR current was small because of their large particle size. In this study, we have tried to prepare titanium oxide-based nano particles using multi-walled carbon nano-tubes (CNTs) as support via hydrolysis method. We examined the effect of heat-treatment condition such as temperature and time on the ORR activity. We prepared Nb doped titanium oxide [mass ratio of TiO 2 :Nb 2 O 5 = 8:2] supported CNTs with total oxide mass ratio of 20wt%. These catalysts were heat treated at 600-900 o C for 0-60 min under 4%H 2 /Ar atmosphere. The catalyst without heat-treatment had poor ORR activity. The heat-treatment under reductive atmosphere enhanced the ORR activity of the catalysts. Figure 1 shows the dependence of the ORR current at 0.6 and 0.7 V of the catalysts prepared at several temperatures for 10 min under 4%H2/Ar in 0.1M H 2 SO 4 at 30 o C. The catalyst prepared at 800 o C showed highest ORR activity. The SEM observation indicated that the sizes of the oxide-based particles were around 20 nm for all catalysts with and without heat treatment. Therefore, the surface area of the oxide-base particles was almost the same. The dependence of the ORR activity was not responsible for the change of the surface area. The XRD patterns revealed that the catalyst without heat treatment was composed of anatase phase of TiO 2 , and the peaks due to the rutile TiO 2 apparently appeared at around 700-800 o C. In particular, the peaks due to Rutile TiO 2 shifted at lower angular, suggesting that the niobium doped into the TiO 2 phase. Thus, the Nb doping into rutile TiO 2 could affect the ORR activity. Figure 2 shows the Ti 2p XPS spectra of these catalysts. As shown in Fig.2, the peak at 457.8 eV corresponding to Ti 3+ (Ti 2 O 3 ) as well as the peak at 459.2 eV corresponding to Ti 4+ (TiO 2 ) were observed. The peak due to Ti 3+ increased from 600 to 800 o C, and decreased at 900 o C. This behavior was well corresponded to the ORR activity. Therefore, we concluded that Ti 3+ could act as active sites for the ORR. According to the XRD patterns, the Nb doping into rutile TiO 2 proceeded with increasing the temperature from 700 to 800 o C. The niobium doping generated the Ti 3+ via electro-neutral principle. The formation of the Ti 3+ in TiO 2 rutile phase was considered to be essential for emergence of the ORR. [1] A. Ishihara et al., J. Electrochem. Soc, 163(7), F603 (2016). Figure 1

Radiation-induced synthesis of carbon-supported niobium oxide nanoparticle catalysts and investigation of heat treatment conditions to improve the oxygen reduction reaction activity

Emergence of Oxygen Reduction Activity in Niobium-Doped Titanium Oxides As Non-Platinum Cathode for PEFCs

Oxygen Reduction Reaction Via the 4-Electron Transfer Pathway on Transition Metal Hydroxides

Highly Active Cofe Alloy Nanoparticlesencapsulated in N-Doped Carbon Nanostructures for Oxygen Reduction Reaction in Both Alkaline and Acidic Media

Nanostructured Niobium and Titanium Carbonitrides as Electrocatalyst Supports

Oxygen Electroreduction on Heat-Treated Multi-Walled Carbon Nanotubes Supported Iron Polyphthalocyanine in Acid Media

Facile Aqueous Phase Synthesis of Carbon Supported B-doped Pt3Ni Nanocatalyst for Efficient Oxygen Reduction Reaction

Nitrogen, Sulfur and Fluorine Tri-Doped Carbon Supporting Cobalt Nanoparticles for Oxygen Reduction Catalysis

Synergistic effects of microstructures and active nitrogen content on the oxygen reduction reaction performance of nitrogen-doped carbon nanofibers via KOH activation heat treatment

Electrocatalysis of Co/CoxOy nanofilms supported by synchronously nitrogen-doped Ketjenblack carbon towards oxygen reduction reaction

Nitrogen-Doped Carbon Activated in Situ by Embedded Nickel Through the Mott-Schottky Effect for the Oxygen Reduction Reaction.

Oxygen Reduction Activity of Carbon Nitride Supported on Carbon Nanotubes

PtNi Alloy Nanoparticles Grown in situ on Nitrogen doped Carbon for Efficient Oxygen Reduction Reaction

Nanoreactor of Nickel-Containing Carbon-Shells as Oxygen Reduction Catalyst.

High‐Temperature Confinement Synthesis of Supported Pt–Ni Nanoparticles for Efficiently Catalyzing Oxygen Reduction Reaction

A Non-Noble Material Cathode Catalyst Dual-Doped with Sulfur and Nitrogen As Efficient Electrocatalysts for Oxygen Reduction Reaction

Core-shell Co@Co3O4 nanoparticle-embedded bamboo-like nitrogen-doped carbon nanotubes (BNCNTs) as a highly active electrocatalyst for the oxygen reduction reaction.

Boosting the oxygen reduction reaction using high surface area graphitic-N dominant nitrogen doped carbon

Boron and Nitrogen Co-doped Molybdenum Carbide Nanostructures for Oxygen Reduction Electrocatalysis

Facile synthesis of Ni-based oxides nanocatalyst: effect of calcination temperature on NRR properties of NiO

Cr2O3 nanoparticles boosting Cr–N–C for highly efficient electrocatalysis in acidic oxygen reduction reaction