Abstract:Support vector machines and a Kalman-like observer are used for fault detection and isolation in a variable speed horizontal-axis wind turbine composed of three blades and a full converter. The support vector approach is data-based and is therefore robust to process knowledge. It is based on structural risk minimization which enhances generalization even with small training data set and it allows for process nonlinearity by using flexible kernels. In this work, a radial basis function is used as the kernel. Different parts of the process are investigated including actuators and sensors faults. With duplicated sensors, sensor faults in blade pitch positions, generator and rotor speeds can be detected. Faults of type stuck measurements can be detected in 2 sampling periods. The detection time of offset/scaled measurements depends on the severity of the fault and on the process dynamics when the fault occurs. The converter torque actuator fault can be detected within 2 sampling periods. Faults in the actuators of the pitch systems represents a higher difficulty for fault detection which is due to the fact that such faults only affect the transitory state (which is very fast) but not the final stationary state. Therefore, two methods are considered and compared for fault detection and isolation of this fault: support vector machines and a Kalman-like observer. Advantages and disadvantages of each method are discussed. On one hand, support vector machines training of transitory states would require a big amount of data in different situations, but the fault detection and isolation results are robust to variations in the input/operating point. On the other hand, the observer is model-based, and therefore does not require training, and it allows identification of the fault level, which is interesting for fault reconfiguration. But the observability of the system is ensured under specific conditions, related to the dynamics of the inputs and outputs. The whole fault detection and isolation scheme is evaluated using a wind turbine benchmark with a real sequence of wind speed.

Intelligent wind turbine sensor fault detection on benchmark model using support vector machine

Combination of Model-based Observer and Support Vector Machines for Fault Detection of Wind Turbines

Finite-time fault detection and reconstruction of permanent magnet synchronous generation wind turbine via sliding mode observer

Enhancing Wind Turbine Performance: Statistical Detection of Sensor Faults Based on Improved Dynamic Independent Component Analysis

Fault Detection of Wind Turbine Generator Bearing Using Attention-Based Neural Networks and Voting-Based Strategy

Uncovering sensor faults in wind turbines: An improved multivariate statistical approach for condition monitoring using SCADA data

Research on Fault Diagnosis of Wind Turbine Based on WPA and RF

Support Vector Machine Used To Diagnose The Fault Of Rotor Broken Bars Of Induction Motors

Fault Diagnosis of Direct-Drive Wind Turbine Based on Support Vector Machine

Wind Turbine Fault Detection with Multimodule Feature Extraction Network and Adaptive Strategy

FAULT MONITORING ON THE KEY MECHANICAL PARTS OF WIND TURBINE BASED ON SVR OBSERVERS

Classification of Demagnetization Faults based on Performance Evaluation of Machine Learning Algorithms via Flux and Vibration Signals in Permanent Magnet Wind Turbine Generator

On Fault Prediction for Wind Turbine Pitch System Using Radar Chart and Support Vector Machine Approach

Fault detection of a wind turbine generator bearing using interpretable machine learning

SCADA-data-based wind turbine fault detection: A dynamic model sensor method

Artificial neural network and empirical mode decomposition based imbalance fault diagnosis of wind turbine using TurbSim, FAST and Simulink

Wind Turbine Fault Diagnosis and Predictive Maintenance Through Statistical Process Control and Machine Learning

Support Vector Machine Classification of Current Data for Fault Diagnosis and Similarity-Based Approach for Failure Prognosis in Wind Turbine Systems

Vibration Fault Detection in Wind Turbines Based on Normal Behaviour Models without Feature Engineering

Vibration Analysis for Fault Detection of Wind Turbine: New Methodology of Supervised Machine Learning Techniques

Research on Fault Detection for Three Types of Wind Turbine Subsystems Using Machine Learning