Abstract:Support vector machines and a Kalman-like observer are used for fault detection and isolation in a variable speed horizontal-axis wind turbine composed of three blades and a full converter. The support vector approach is data-based and is therefore robust to process knowledge. It is based on structural risk minimization which enhances generalization even with small training data set and it allows for process nonlinearity by using flexible kernels. In this work, a radial basis function is used as the kernel. Different parts of the process are investigated including actuators and sensors faults. With duplicated sensors, sensor faults in blade pitch positions, generator and rotor speeds can be detected. Faults of type stuck measurements can be detected in 2 sampling periods. The detection time of offset/scaled measurements depends on the severity of the fault and on the process dynamics when the fault occurs. The converter torque actuator fault can be detected within 2 sampling periods. Faults in the actuators of the pitch systems represents a higher difficulty for fault detection which is due to the fact that such faults only affect the transitory state (which is very fast) but not the final stationary state. Therefore, two methods are considered and compared for fault detection and isolation of this fault: support vector machines and a Kalman-like observer. Advantages and disadvantages of each method are discussed. On one hand, support vector machines training of transitory states would require a big amount of data in different situations, but the fault detection and isolation results are robust to variations in the input/operating point. On the other hand, the observer is model-based, and therefore does not require training, and it allows identification of the fault level, which is interesting for fault reconfiguration. But the observability of the system is ensured under specific conditions, related to the dynamics of the inputs and outputs. The whole fault detection and isolation scheme is evaluated using a wind turbine benchmark with a real sequence of wind speed.

FAULT MONITORING ON THE KEY MECHANICAL PARTS OF WIND TURBINE BASED ON SVR OBSERVERS

Fault Detection Based on Operational State Recognition for Wind Turbine Gearbox

Finite-time fault detection and reconstruction of permanent magnet synchronous generation wind turbine via sliding mode observer

Condition Monitoring for Roller Bearings of Wind Turbines Based on Health Evaluation under Variable Operating States

Condition Monitoring And Fault Diagnosis Of Rotating Machines With Blind Source Separation

Fault Detection of Wind Turbine Generator Bearing Using Attention-Based Neural Networks and Voting-Based Strategy

Combination of Model-based Observer and Support Vector Machines for Fault Detection of Wind Turbines

On-line condition monitoring for rotor systems based on nonlinear data-driven modelling and model frequency analysis

Fault Detection of WECSs Based on Improved SVO and Fourier Transformation

An early fault warning and diagnosis model based on a two-step analysis strategy for wind turbine bearings

Adaptive and Self-supervised Condition Monitoring Method for Machinery

Identification Of Multi-Concurrent Fault In A Steam Turbine Rotor System Using Model-Based Method

Main bearing Main shaft Gearbox Generator shaft Generator Gearbox bearing Brake Rotor

Fault detection in wind turbine transmission systems via finite frequency observers

Pitch angle control with fault diagnosis and tolerance for wind turbine generation systems

The fault prediction in wind turbine based on temperature model of bearings

Hierarchical Cluster Balance Representation and Temporal-Spatial Collaborative Modeling for Nonstationary Wind Turbine Monitoring

Intelligent Monitoring and Optimization of Wind Turbine Operation Status on Basis of Vibration Signals

Simulation and feature extraction of inter-shaft bearing fault in rotor-bearing-casing system

A NARX Model-Based Condition Monitoring Method for Rotor Systems

Bearing Fault Diagnosis under Time-Varying Speed and Load Conditions Via Observer-Based Load Torque Analysis