Abstract:Support vector machines and a Kalman-like observer are used for fault detection and isolation in a variable speed horizontal-axis wind turbine composed of three blades and a full converter. The support vector approach is data-based and is therefore robust to process knowledge. It is based on structural risk minimization which enhances generalization even with small training data set and it allows for process nonlinearity by using flexible kernels. In this work, a radial basis function is used as the kernel. Different parts of the process are investigated including actuators and sensors faults. With duplicated sensors, sensor faults in blade pitch positions, generator and rotor speeds can be detected. Faults of type stuck measurements can be detected in 2 sampling periods. The detection time of offset/scaled measurements depends on the severity of the fault and on the process dynamics when the fault occurs. The converter torque actuator fault can be detected within 2 sampling periods. Faults in the actuators of the pitch systems represents a higher difficulty for fault detection which is due to the fact that such faults only affect the transitory state (which is very fast) but not the final stationary state. Therefore, two methods are considered and compared for fault detection and isolation of this fault: support vector machines and a Kalman-like observer. Advantages and disadvantages of each method are discussed. On one hand, support vector machines training of transitory states would require a big amount of data in different situations, but the fault detection and isolation results are robust to variations in the input/operating point. On the other hand, the observer is model-based, and therefore does not require training, and it allows identification of the fault level, which is interesting for fault reconfiguration. But the observability of the system is ensured under specific conditions, related to the dynamics of the inputs and outputs. The whole fault detection and isolation scheme is evaluated using a wind turbine benchmark with a real sequence of wind speed.

Fault detection in wind turbine transmission systems via finite frequency observers

Finite-time fault detection and reconstruction of permanent magnet synchronous generation wind turbine via sliding mode observer

Fault Detection Based on Operational State Recognition for Wind Turbine Gearbox

Fault detection observer design for Takagi-Sugeno fuzzy systems with finite-frequency specifications

Observer-Based Robust Fault Predictive Control for Wind Turbine Time-Delay Systems with Sensor and Actuator Faults

Zonotopic Fault Detection Observer Design for Takagi–Sugeno Fuzzy Systems

Fault Detection Observer Design in Finite‐frequency Domain for Lipschitz Non‐linear Systems

Fault Detection of WECSs Based on Improved SVO and Fourier Transformation

Fault Detection for Lipschitz Nonlinear Systems with Restricted Frequency-Domain Specifications

FAULT MONITORING ON THE KEY MECHANICAL PARTS OF WIND TURBINE BASED ON SVR OBSERVERS

Adaptive Event-Triggered Finite-Frequency Fault Detection With Zonotopic Threshold Analysis for LPV Systems

Weak Fault Detection of Rotor Winding Inter-Turn Short Circuit in Excitation System Based on Residual Interval Observer

An Optimal Fault Detection Approach for Piecewise Affine Systems Via Diagnostic Observers.

A Novel Method for Fault Detection in Singularly Perturbed Systems Via the Finite Frequency Strategy

H−/L∞ Fault Detection Observer Design for Uncertain Takagi-Sugeno Fuzzy Systems

On-Line Fault Detection in Wind Turbine Transmission System Using Adaptive Filter and Robust Statistical Features

<i>H</i>-/<i>L</i><sub>∞</sub> fault detection observer design for uncertain linear systems

L∞ Fault Estimation Observer Design for Discrete-Time Linear Parameter-Varying Systems

Combination of Model-based Observer and Support Vector Machines for Fault Detection of Wind Turbines

Fault Detection for Takagi–Sugeno Fuzzy Systems Using Multiple Observers and Ellipsoidal Analysis