Abstract:Concrete floors and ground slabs in building frames contribute significantly to the overall embodied CO 2 footprint of concrete. One promising way to reduce the environmental impact is to tailor the concrete properties within a slab to meet spatially varied performance requirements such that concrete with a higher cement content is used only where necessary. An experimental programme to investigate simply-supported functionally layered slabs with either horizontal or vertical layers was undertaken to ascertain whether a desired serviceability performance can be achieved in tandem with a relatively lower embodied CO 2 . The test matrix compared three single mix slabs, two horizontally layered slabs with different layer thicknesses and two vertically layered slabs with different zonations. The slabs were 1200 mm long by 500 mm wide and either 120 or 160 mm thick. Conventional concrete materials consisting of a high strength (target compressive strength of 60 MPa) and a low strength (target compressive strength of 20 MPa) concrete mix were layered. The influence of the concrete mix properties, the tensile horizontal high strength layer thickness (20 mm or 56 mm) and the location of the high strength concrete (in the interior 233 mm width or exterior 133 mm wide regions) in a slab with vertical interfaces were probed. The layers were cast in the fresh-state with less than a 30 min pour delay to promote hydration across the interfaces. The one-way spanning slabs were tested in four-point bending where the distance between supports was 1000 mm and the shear span was 250 mm. The horizontally layered slab with a 56 mm high strength concrete layer had a higher elastic stiffness and provided an uplift in first cracking moment of around 60 % relative to an analogous single mix low strength concrete slab. Beneficial restraint between weaker and stronger mixes across vertical interfaces led to an approximately 30 % increase in cracking load relative to the single mix lower strength slab. It was observed that the placement of the stronger mix in the exterior regions bounding the weaker mix was the preferable vertical layout in terms of reaching a greater peak load at failure. Functionally layered concrete can help to rationalise the overall embodied CO 2 of reinforced concrete slabs while concurrently satisfying desired serviceability and ultimate limit state requirements.

THE FLEXURAL BEHAVIOR OF HOLLOW CORE CONCRETE SLABS WITH DIFFERENT SHAPE

Simplified Calculation of Normal Section Bearing Capacity of Cast-in-situ Reinforced Concrete Two Direction Hollow Slab

Flexural behavior of two-layer reinforced concrete slab with hollow cores

Bending behaviour of precast concrete slab with externally flanged hollow FRP tubes

Tension stiffening in reinforced concrete hollow core slabs

Structural Behavior of Reinforced Concrete Hollow Core Slabs Cast with Self-Compacting Concrete Containing Recycled Concrete as Coarse Aggregate

Experimental study on the flexural performance of concrete hollow composite slabs with tightly connected panel sides

Evaluation of Flexural Behavior of Prestressed Concrete (PSC) Hollow-Core Slabs (HCSs)

Behavior of a Two-Way Lightweight Steel–Concrete Composite Slab Voided with Thin-Walled Core Boxes towards Sustainable Construction

Structural Behaviour of Voided Flat Slab With Various Void Ratios Under Vertical Loading

Experimental Investigation on the Effect of Steel Fibers on the Flexural Behavior and Ductility of High-Strength Concrete Hollow Beams

Flexural behavior of 15-year-old full-scale hollow slab beams strengthened with fiber-reinforced composites

EXPERIMENTAL STUDY ON FLEXURAL BEHAVIOR OF PRECAST CONCRETE HOLLOW SLAB CONNECTED BY MONOLITHIC SEAM

Comparative Study of Numerical Methods for Predicting Crack Propagation in Reinforced Concrete Hollow Core Slabs

Flexural behaviour of functionally graded reinforced concrete slabs with vertical or horizontal layers

Bearing Capacity And Deformations When Bending The Multi-Hollow Floor Slab With Stops At The Ends (In Order Of Discussion)

Strengthening of hollow core precast prestressed reinforced concrete slabs using different techniques

RESEARCH OF THE STRESS-STRAIN STATE OF PRECAST REINFORCED CONCRETE HOLLOW CORE SLABS UNDER THE ACTION OF A CONCENTRATED AND UNIFORMLY DISTRIBUTED LOAD

Experimental, theoretical and numerical study on flexural behavior of hybrid steel‐GFRP reinforced concrete slabs

Flexural performance of a fully-prefabricated concrete slab with double-grouted sleeve connectors: An experimental and theoretical study

Flexural behaviour of semi-precast slabs of fibre-reinforced concrete reinforced with prestressed basalt fibre-reinforced polymer and steel bars