Abstract:Presented in this study is investigation of dynamic behavior of a helical gear reduction by experimental and numerical methods. A closed-loop test rig is designed to measure vibrations of the example system, and the basic principle as well as relevant signal processing method is introduced. A hybrid user-defined element model is established to predict relative vibration acceleration at the gear mesh in a direction normal to contact surfaces. The other two numerical models are also constructed by lumped mass method and contact FEM to compare with the previous model in terms of dynamic responses of the system. First, the experiment data demonstrate that the loaded transmission error calculated by LTCA method is generally acceptable and that the assumption ignoring the tooth backlash is valid under the conditions of large loads. Second, under the common operating conditions, the system vibrations obtained by the experimental and numerical methods primarily occur at the first fourth-order meshing frequencies and that the maximum vibration amplitude, for each method, appears on the fourth-order meshing frequency. Moreover, root-mean-square (RMS) value of the acceleration increases with the increasing loads. Finally, according to the comparison of the simulation results, the variation tendencies of the RMS value along with input rotational speed agree well and that the frequencies where the resonances occur keep coincident generally. With summaries of merit and demerit, application of each numerical method is suggested for dynamic analysis of cylindrical gear system, which aids designers for desirable dynamic behavior of the system and better solutions to engineering problems.

Design and simulation of gear transmission system based on metamaterial

The Influence of Coupling Misalignment on Dynamic Characteristics of Helical Gear System

Simulation Analysis of a Novel Magnetic Gear

Structural design and dynamic analysis of a metal rubber composite gear pair

Analysis of machining errors' effects on gear pair meshing using contact finite element method

Dynamic modeling of a gear transmission system containing damping particles using coupled multi-body dynamics and discrete element method

Continuously tunable mechanical metamaterials based on gear cells

Nonlinear Dynamic Simulation Of Coupled Lateral-Torsional Vibrations Of A Gear Transmission System

Theoretical and Experimental Study on Non-Linear Vibration Characteristic of Gear Transmission System

Dynamic investigation and experimental validation of a gear transmission system with damping particles

A novel dynamic modeling method with slice coupling for thin-rimmed gear transmission

Analysis on the vibration reduction for a new rigid–flexible gear transmission system

Dynamic analysis of a helical gear reduction by experimental and numerical methods

Optimization design for dynamic characteristics of face gear drive with surface-active modification

Parametrical Design and Simulation of Gear Transmission based on OpenGL

Analysis of Vibration Characteristics of Face Gear powering-split Transmission System

Precise modeling of complex tooth surface microtopography and multi-degree-of-freedom nonlinear friction dynamics for high-performance face gear

Dynamics Modeling and Experimental Investigation of Gear Mechanism with Coupled Small Clearances

Dynamic modeling and analysis of high-speed flexible planetary gear transmission systems

Hybrid Dynamic Modeling and Analysis of High-Speed Thin-Rimmed Gears

Parametrical Design and Simulation of 3D Geometry Model for Straight Gear Transmission