Abstract:Molten lead (Pb) and its alloys (PbBi and PbLi) are of immense interest for various nuclear engineering applications, including but not limited to advanced Lead-cooled Fast Reactors (LFRs), tritium Breeding Blankets (BBs) of fusion power plants and spallation targets for Accelerator-Driven Systems (ADS). Owing to their attractive thermophysical properties, these advanced fluids assert their candidacy to address the critical requirements of neutron multiplication, neutron moderation, high temperature coolants and tritium breeders, enabling the operation of next generation nuclear systems at high temperatures with better efficiencies. However, for numerous reasons such as a compromise of structural integrity at the heat transfer interface, presence of an inert cover gas during charging of molten metal in the loop, and the fusion fuel cycle itself may lead to molten metal-gas two-phase flows with high density ratios. At present, no effective diagnostics exist to detect such operational and accidental occurrences in high temperature molten metal systems resulting in a severe lack of relevant experimental studies. To address these limitations and to advance the current understanding toward two-phase regimes in high temperature Pb-based melts, the present work focuses on the design and assembly aspects of an electrical conductivity-based two-phase detection sensor array, utilizing high purity α-Al 2 O 4 coatings with AlPO 4 binder as electrical insulation layers. This paper discusses the design considerations, thermal analysis, systematic selection of structural/functional components along with preliminary results from the probe performance tests in very high temperature (600°C) static molten Pb column for real time detection of argon gas bubbles rising within the melt. Quantitative estimations of time-averaged void fraction, average bubble impaction frequency and average bubble residence time are presented from the preliminary experimental investigations.

Development of Compact Multivariable Probe for Two-Phase Detection in PbLi-Argon Columns

Design, fabrication and validation of an electrical conductivity principle based two-phase detection sensor array for molten lead (Pb) based heavy metal coolants up to 600^∘C

A New Contactless Bubble/Slug Velocity Measurement Method of Gas–Liquid Two-Phase Flow in Small Channels

Development of Diagnostics for High-Temperature High-Pressure Liquid Pb-16Li Applications

A C~4D-Based Measurement System of Gas-Liquid Two-Phase Flow

ACOUSTIC PROPERTIES OF Pb-17Li ALLOY FOR ULTRASONIC DOPPLER VELOCIMETRY

Development and validation of electrical-insulating Al2O3 coatings for high-temperature liquid PbLi applications

PHASE DETECTION AIDED THERMOMETRY AND ITS APPLICATION TO NATURAL CONVECTIVE SUBCOOLED FLOW BOILING IN A NARROW GAP

Ultrasonic Doppler Velocimetry Experiment of Lead-Lithium Flow with Oroshhi-2 Loop

Electromagnetic Field and Temperature Field Analysis of Coil Type Lead-Bismuth Electromagnetic Flowmeter

Local Measurement of Bubbly Flow in Helically Coiled Tubes Using Double-Sensor Conductivity Probe

Phase Identification by a Novel Needle-Contact Capacitance Probe in Gas-Liquid Two-Phase Flows

Double Flush-Mounted Probe Diagnostics and Data Analysis Technique for Argon Glow Discharge Plasma

Liquid–Solid Triboelectric Probes for Bubbles Status Monitoring

Four-sensor droplet-capable conductivity probe in annular and wispy-annular flows

Developing the next generation of dual-tip phase-detection probes for air-water flow experiments

Local Measurement of Gas-Liquid Bubbly Flow with A Double-Sensor Probe

High temperature ultrasonic transducers for imaging and measurements in a liquid Pb/Bi eutectic alloy

Measurements of Local Liquid Velocities in Gas-Liquid Two-Phase Flows

Position Reconstruction of Bubble Formation in Liquid Nitrogen using Piezoelectric Sensors

Numerical analysis and structural optimization of a DLC coated capacitance wire-mesh sensor for measuring liquid metal-gas two-phase distribution