Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Theoretical study on mechanism of benzene to phenol over VAPO-5 molecular sieve

Kinetic Modeling of C2–C7 Olefins Interconversion over ZSM-5 Catalyst

Study on Complex Reaction Network and Kinetic Model of a Methanol to Propene Process

Computational Study of Polycyclic Aromatic Hydrocarbons Growth by Vinylacetylene Addition

A kinetics study on microwave-assisted catalytic hydrogenolysis of benzyl phenyl ether

Synthesis of Hierarchical MeAPO-5 Molecular Sieve and Optimization of its Catalytic Oxidation of Benzene to Phenol Based on Response Surface Method

Study on in-situ catalytic conversion of alcohols to aromatics and its mechanism

Combined Computational and Experimental Investigation on the Fenton Reagent Catalysed Hydroxylation of Benzene

Numerical Simulation of PAH Formation Process in Ethanol/n-Heptane Combustion Flame

The Direct Hydroxylation of Benzene to Phenol Catalyzed by Fe-ZSM-5 Zeolite: A DFT and Hybrid MP2:DFT Calculation

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Alkylation of Benzene by Methanol: Thermodynamics Analysis for Designing and Designing for Enhancing the Selectivity of Toluene and Para -Xylene

Possible active sites in Fe/ZSM-5 zeolite for the direct benzene hydroxylation to phenol: 1. μ-Oxo[Fe, M] species (M = Fe, Al)

Theoretical investigation of the paring mechanism of the MTO process in different zeolites

Mechanistic Characterization of Zeolite-Catalyzed Aromatic Electrophilic Substitution at Realistic Operating Conditions

Molecular Study of Phenyl Formation on ZSM-5: Comparison between Surface and Gas Phase Reactions

Sodium Catalytic Benzopentazole Cracking: A Theoretical Study

Amorphous Vanadium Oxide Supported on Activated Carbon Prepared by Dielectric Barrier Discharge as an Efficient and Stable Catalyst for Hydroxylation of Benzene to Phenol

Comprehensive mechanism and microkinetic model-driven rational screening of 4N-modulated single-atom catalysts for selective oxidation of benzene to phenol

Mechanistic investigation of methanol-to-olefins conversion catalyzed by H-ZSM-5 zeolite: a DFT study

A theoretical study on the mechanism and kinetic of the reaction between ozone and benzene